Recent content by zimcocomp

  1. zimcocomp

    Kubota selector valve installation

    I have a 1986 Kubota L2550. What happens if you connect the selector valve into the bucket curl valve hydraulics? Is this a problem and I should hook into the boom hydraulics? Thank you.
  2. zimcocomp

    Kohler K532 - Intermittent Issues (Fuel?)

    You installed an electric fuel pump in line with the engines pump. Did you try turning off the electric pump and run engine? This would require a pump that allows flow through when off. If you were successful could you tell me the brand? I have a Bolens QT16 and I want to use the pump as a...
  3. zimcocomp

    Removal of the engine Bolens QT16

    Any tricks to getting the drive shaft off between the Kohler engine and the hydraulic drive unit on a Bolens QT16? Must be some rust holding them together.
  4. zimcocomp

    Convert gas generator to propane???

    Just a follow up from my idea of conversion back in 2013. Completed the conversion back then and I must say I have had no problems of any kind. It starts and runs quite well even down below -10 degrees. Even with a 100 lb. tank. I used to have carb problems fairly often if it didn't get started...
  5. zimcocomp

    Loader  BF400G loader removal off L2550 Kubota

    I need help figuring out how to remove the BF400G FEL from my L2550 Kubota. I have the four legs for it but what do I do?
  6. zimcocomp

    Bolens QT series engine replacement

    Has anyone replaced the Kohler engine in a Bolens QT 16. Looking for workable substitute engine. Any suggestions?
  7. zimcocomp

    Quick Hitches  3 point quick connect hitch for lift arms

    Does anyone have the quick connect ends for the 3 point hitch from Palletforks.com (Titan)? I need the measurement from the center of the lift arm pin to the top of the quick connect end. My back hoe has only a little clearance from the mounting pin to the bottom of the oil storage tank. Thank you.
  8. zimcocomp

    Convert gas generator to propane???

    Has anyone had experience converting a gasoline powered generator to propane? I have a Generac 10000EXL using a 19 HP GN-570 gas engine and I am looking into a conversion kit to run it on propane to eliminate the old fuel problem. Has anyone had experience in doing this and where can you get...
  9. zimcocomp

    Foundation repair

    I have a problem with rot on my foundation on one side where the ground level is too close to the top of the foundation. My plan is to replace the sill and that does not bother me. What I would like to do is raise the ground level along side the foundation but to do that it would put the level...
Top