so I have a ford 4610 and just replaced the rear bearings and seals. I didn't have a dial indicator and didn't have a pack of shims and going on a dealer telling me that I'd probably be alright i just went ahead and did it. The job wasn't hard but after putting it back together i got myself a...
I got myself into a little questionable scenario regarding these spring trips.
I bought a couple Kubota L245h for our veggie farm and got a wicked deal on them b\c they didn't have the underbelly mounts for the cultivator. Being a pretty crafty welder and machinist i whipped up some really nice...
I bought a couple Kubota L245h from a dealer down in kentucky. I couldn't go down and look at them so i took him on his word. Needless to say everyone i bought but this one is in good condition.
The 3 point lift arm lever is snapped off on this machine and before i got to far into it I wanted...
I have a ford 4610 with a loader. The loader is plumbed into the rear remotes. These both have detents. The previous owner used it for his silage loader and I am finding the detents to be extemely cumbersome for what i need the loader to do.
Can the detents be reduced or adjusted, perhaps...
I purchased a ford 4610 last year and love the tractor. Our veggie farm does alot of transplanting and I noticed on new hollands site they have a creeper gear box addon for this model as well as some of the other 10 series. I have a syncromesh transmission.
the dealers say it is not made and...
I was curious if anyone has made or has plans for a plastic mulch layer or bed shaper.
I have looked at some of the pictures. The design of some basic ones look simple but i was curious if anyone has knowledge of the resistance mechanism on the mulch roll? If any at all.
Just looking for some...