Good evening!
I'm in the process of getting an older FRC800 tiller back into working condition and need to purchase a new belt. From what I can tell, I'm looking at Honda 22431-765-631 also called 'SB-48'.
Holy crap does the local place want a lot of cash for the specific Honda belt.
Anyone's...
I do have two identical housing+bearing assemblies. Thank you for the manual. Am I reading the parts diagram included incorrectly? It seems like it calls for duplicates of everything bearing cage/bearing related. The part I ordered two of from Flailmaster was the "M-702408", which references the...
You're here spending your free time helping someone you've never met out. I'll be out there with a camera all night if it makes this easier to resolve.
This is with the old assembly, and is the inside of the mower, the 1/2" metal piece that sticks through the side of the mower is part of the...
Since I already had it apart, i tossed the old housing & bearing back on to check fit. Shaft is still recessed a bit, but not nearly as much as with the new bearings. Spacing it hard to see here, but its 3.25mm in.
I assume I can shift the shaft a bit before tightening the set screws. The...
The housing itself sits tight against the frame. The bolts that hold the housing on force it as tight as possible. You're right, that the distance the that the shaft is recessed is more than how proud the bearing stands.
I pulled the new housing off again, and took photos of it side by side...
Good Evening. I have an old Mott 72 flail which needed to have the cutter shaft bearings replaced. I ordered a pair of the M-702408 bearing + housing combos from Flailmaster. Housing itself looks the very similar to the old one, with three bolt holes that line up great and grease zerks on the...