zzvyb6's latest activity

The drawbar length sets the position of the hitch pin relative to the tractor's pto shaft's u-joint coupling on a driven shaft. This...

Incorrect. It requires equal co-linear AND co-planar alignment of the input and output shafts, with the center of the intermediate...

I'll agree with the other suggesting a new shaft for the front one. Also your drawbar is set to short, your drawbar hitch pin should be...

Although I disapprove of my doggos being anywhere near my machinery, here is the rest of the pack:

I just bought a 55" collapsed length 540 tractor end 21 spline baler end, CV jointed + slip clutch for $600 from this place. It weighs...

On the long shaft setup you should get a CV joint at the tractor end because angle differences will excite some serious vibration and...

My F-935 with a front mount 76" triple spindle rear discharge deck makes it thru tall grass, hay, twigs and shrubs without a complaint...

Do you realize that this forum is actually a form of A.I. ? It's just a collection of feelings and opinions about accomplishing some...

Like so:

From the video, it's pretty obvious that the shaft connected to the tractor's pto has been assembled incorrectly. The Cardan yokes are...

I can't tell from the dark photo at the tractor end, but first suspicion is that one of the PTO shafts is mis-phased. This are probably...

Firstly is it possible that the shaft is being asked to collapse to less than its min ? Consider odd situations : mower rear raising up...

Why the high RPM when engaging and disengaging the PTO? Not that it should break fasteners, but I always use the lowest RPM possible.

Consider removing it and using a lateral drawbar attached between the lower links. This will/may require a longer PTO shaft as well...

A lot of people I know had to withdrawn because of year before's income tax debt. Mine is way up. I live off of 4 S.P.I.A.s that pay me...