Search results

The 3 point lift arms on my John Deere 5300 utility tractor are dropping. This started when the tractor was not running, but recently it will do it while the tractor is running also. There are no external leaks. I am hoping someone has had a similar issue with a similar tractor and has an idea...

2006 (I think) RTV-900 with 1800 hours. when shifting into forward or reverse and depressing the accelerator, the unit revs but does not move. It is sometimes helpful to go back to N, rev the engine, and put it back in gear, and it will usually move. If you rev the engine while in F or R it...

I have replaced hoses on a no till drill. The raise and lower cylinders are installed in series. The cylinders are rephasing type, one with a 3.25 inch bore, and one with a 3 inch bore. The cylinders are mounted vertically, and I did lose a little fluid out of the lower fittings when I removed...

2013 JD 5085e, cab, FEL, 380 hrs. I have noticed the last couple of days putting out hay etc., a noticeable increase in the engine "dieseling" under virtually no load. My first thought is a fuel issue, but was wondering if anyone else had encountered this. Any thoughts would be appreciated.

JD 5300 with 520 FEL connected to the rear scv outlets. To use a rear mounted implement such as a disc mower or tedder with a single hydraulic function I have always disconnected what I think is the "A" coupler (raise function for the loader) and connected the implement. The disc mower should...

JD 5300 w 520 FEL. No mid mount hydraulics, so the loader is connected to the rear SCV's. I have disconnected and re connected many times with no issues (I use the raise and lower outlets because I need to use the float position) Recently I started getting a drip out of one, and then both of the...

Good morning. I have encountered a recurring fuel issue with my JD 5300. It started with the rpm's increasing on their own, which I understand is a sign of the engine starving for fuel. Shortly after that starts the engine will shut off. I had put a few hundred hours on the tractor before this...

Recently started working on a 763C with the Kubota engine. The unit has been sitting for several years, but initially cranked as it always had. After adding fuel, we can not get any fuel to the primer bulb, nor will it flow with the bulb removed. Is there a solenoid or check valve on the fuel...

1996 JD 5300 with collar shift transmission. The gear shift has lost its normal side to side travel limits and instead has to be pulled far to the left (against the set bottom nearly) to engage the left two gears (reverse over and back etc.) It is like the lever has lost its travel restriction...

I am in the learning curve on tractor repair and maintenance, so thanks in advance for any replies and or advice. Included in a larger purchase of equipment was a JD 5300 tractor (3200 hrs, 2wd, collar shift trans). The first symptom was when changing FEL attachments. The inplement attachment...