Search results

***UPDATE: I figured it out... the answer is "no" - when the work ports are active, PB is not pressurized. So you cannot have the auger control in *front* of the FEL and raise/lower/tilt while the auger is spinning. (see below diagram for clarification)

I'm updating to save anyone else from going through the nightmare I had to go through to figure this out... Behold, the manual for a Besko HDM03/02... (took me a month and a dozen trips to hydraulic stores and dealers to track this down)

I have a Prince Wolverine valve (WVS11C5C1) I'm using in a 3rd function setup that I bought from Surplus Center. Does anyone know if the Power Beyond outlet will have pressure when the work ports are activated? Currently I have the FEL controls before the auger valve and it flip-flops...

This is the male end... I counted 6 threads total, 0.732" OD - still trying to locate a protractor to figure out the angle. Haven't used one since grade school... also a bit concerned with that corrosion on the inside.

I asked this question over in the Mahindra section, but I'm not getting any response and my tractor is down until I figure this out -- so needing some help ASAP. I'm setting up a hydraulic auger on my Mahindra 4540 Front End Loader and I have all the hoses and fittings for the new control...

Thats a great link Swampy. Here is what the inside looks like. I'm thinking its an JIC 37 or SAE 45 maybe?

Can anyone tell me what fitting size this is for a Mahindra 4540 Front End Loader? This is the inlet hose that goes from the pump output to the input on the FEL control joystick. I think the control valve is a Besko model, but there is very little/no information out there on it. Thank you

Looking into building a 3rd Function for my Mahindra 4540. Preface - as of two days ago I had no idea what a 3rd function was and had never done any work on my hydraulic system - so go easy on me... Based on ridiculous amounts of research the last two days I've come up with what I *think* is a...

Looking to get a 9" hydraulic auger, only problem is my 4540 didnt come with a 3rd function or rear remotes. I talked to the guys over at EA and he said I should go with rear remotes. The WR Long kit they sell is not designed for auger use. What are my options here? If I buy the kit (dealer...

Hey ya'll... Anyone have experience with the Brush Hog PHDHF15 or HF20? I've been looking at it for my Mahindra 4540. (4WD) Bush Hog recommends 10 gph minimum for the HF20 and the Mahindra only puts out 8.7 according to the specs. Would it still work or would I be putting too much stress on...

Looking at the KK 60" roto-tillers. I have a Mahindra 4540 that see's light-to-medium duty. Would this be a good tiller? It seems like it has pretty good reviews and the price is right. I have 6 100x100ft plots that I'll be alternating through. (two or three a year, on a rotating basis) Thanks...