Search results

A time or 2, but apparently not enough. Thanks for this advice.

Have flushed cooling system and refilled w/ fresh anti-freeze. Awaiting new radiator cap. Thanks for the advice!

Thanks, gents I will get busy with your wise words.

My 10 year old Mahindra has started running hot. The onset is not consistent with either the duration of run time or the actual work being done. I noticed that the radiator hose was collapsed. Would a faulty radiator cap cause this? I discovered that Mahindra will not see a water pump by itself...

I I replaced my Bad Boy Buggy 6 months ago w/ CanAm HD10. Other than my initial fuel concern , I have been exceedingly pleased with it. Extremely comfortable ride and will take me anywhere on my 500 acres… and back. Fuel concern were unwarranted as it has been very fuel efficient. I really...

Thank you for your insight. I’ll check it out.

I have older Mahindra,model 4110. Yesterday after bush-hogging food plots, I can’t get the PTO to turn off. Any suggestions from you tractor gurus?

Thanks gents! I’ll get busy and get Old Daisy up and at it!

Can anyone here give me some advice on getting my Ford 3400 3cylinder diesel to start? The stopcock on the fuel line was turned off by the repair shop without my knowledge and I unknowingly drove it until all of the fuel in the line was exhausted. Of course, I have opened the stopcock, but it...

Connected and reconnected several times, indicator window on tractor indicated full fluid levels. Let tractor idle at 15k-20k rpm for 5+ minutes and still no improvement in response. Thank you for your suggestions. Anything else??

After several months of proper storage, the hydraulics to my MF backhoe will not lift the stabilzers or move the boom. The hoses do “tighten up” and the implement moves just a small amout when manipulating the levers, but thats it. Backhoe is 1 year old…any suggestions are greatly appreciated.

Can anyone advise me about what appears to be a wire descending from ignition switch to a plug (sensor) directly below the ignition switch in the transmission casing.I assume it is a sensor for hydraulic oil. How can one determine if this sensor is defective and how is it removed. Doesn't appear...