Search results

Probably that too but just pulled off distributor cap and found the cover for the points had broken half into. Couldn't find all the pieces to it either. Must have gotten chewed up. Cleaned and blew it out best I could.

Thanks Was going to jump wire the starter but getting the spark makes sense

Had just about finished cut 20 acres. Was going up very small hill and it died. Would not start back up. Is turning over but has that dry sound like it is not getting gas. Towed home. Had trash in bulb so cleaned it. The fuel line and drained out carb. No good. Have had issues of taking along...

53 Jubilee running fine, just cut 20 acres then it died now won't start. Had issues with starting not turning over but turning over now.

I hope not! I didn't know the Difference BUT I guess I understand now. Time to get greasy

Thanks for your help. It is much appreciated. I will try the adjustment. Maybe I will get lucky. Don't want to jump back inside unless I have to. Have a good one

Yes this is the bucket I am using. I am in the top pin hole of picture I attached below of the rocker it is oriented as the picture I will move it down one. Since I am dumping loads on top of loads with the bucket it does have a tendency to push the lift arm up higher. As the bucket flips &...

Draft control was not engaged It is working fine now with me not having a load in bucket. I did engage this disengage the Draft Control. Only thing I noticed was bucket was not quite level so used hand crank to level it. Never had it bind up nor the control lever freezing up. I ran it up and...

Yes it has a draft control. Had issues with hydraulic when first got it. Wouldn't lift heavy loads so pulled off lift cover & took in for repairs. Didn't have trailer to haul tractor. Repair didn't last 2 months had them fix again but made them let me watch. Lasted 6-8 months that time. So i...

Using a pond scoop to make a small levy, so loads can be heavy. 3 pt will raise with heavy load but slowly some times. My issue is after I have dumped a loaded & getting ready to lower scoop to pick up another it will not lower. The CONTROL LEVER GETS VERY HARD TO MOVE & WILL NOT GO DOWN. Even...