Search results

Hey I'm in Southwest Kalamazoo County Texas Corners Mattawan area. Trying to find somebody that I can take my Ford 8N in for some repairs, the Hydraulics won't lift the three-point, I have a squealing noise on either the alternator or something else, I need some other General work done. If...

Hello from the rookie 8N garage again! Now I need to replace the grease boots for sure on the rear drag link end, not sure of the fonts please see pictures, should I rebuild the rear (not sure fronts are gone) the boots are so bad on the rear I wonder the condition of the joint. I am ordering a...

When I'm replacing the leaky PTO shaft seal do i lubricate it and if so with what kind of lubricant? Thank you I know it's probably a dumb question but I've never done it before!

Hey all, I have a 51 8N that the seal on the rear pto leaks bad, it very low on fluid so I'm gonna drain whats left and replace, my question is- When I try to remove the bolts that have never been apart, should I try a breaker bar, 6 or 12 point socket or should I use air impact, seems...

Well I went to plow the drive this am and only 5-10 psi oil pressure when is has run 40-45 too high for 2 years, it was 5 deg F very cold but since I stretched the spring on the relief valve 2 years ago I haven't had this problem if anything too much pressure, I ran the tractor last week and had...

Has anyone put up OSB ceiling on 2' center trusses I have a 24x 32 w/ 10' ceilings would like to know what thickness worked or modifications were made. Thanks

OK so I just disc ed my garden and I'm not happy with it, drove my 8N around in circles in a 30'x40' area not worked ina few years but it just didn't turn out that good? Wondered now that I have mostly bare dirt if I can plow with my 1 bottom plow and then disc again or will I have trouble...

Getting ready to finish barn walls w/ OSB I am going to attach it to the horizontal flat 2x4's & use 1.5" foam sheet insulation. Need to know- -OSB thickness for walls and ceiling -Screws or nails? -Any experiences or mistakes I should know of -suggestions/concerns for pegboard installation in...

New here, joined to get some advise on all my projects- 52 8N 69 112 JD 80 210 JD Finishing Barn Interior, just cleaned out my brother in laws barn after dying of a heart attach at 57. Cleaned out all the stuff he saved for retirement projects that he never got too so I look at things a bit...