Search results

I have put about 300 hours on my 1500D and had installed gauges early on. It always ran about 65psi cold, 50/55 psi when hot around 2200 rpms. Around 1100 rpms when it was idling it would see 45 psi. Recently the gauge was acting up and giving odd readings. I swapped it out and was still...

I recently purchased a 48 Farmall H. I ran it yesterday for 15 minutes when I noticed coolant leaking from the overflow tube. The temp gauge is not working but with a temp gun the back of the head only read 144 F. I'm trying to determine what to inspect/replace. Not sure if it has the right...

Morning all. Just looking for any advice on replacing the head gasket in my 1500D. I started getting coolant in the oil the other day. It seems that a stud may have loosened in the cold weather. The head is off and I have checked it with a straight edge. It checked out straight. At this point...

Hi all. I'm usually in the Yanmar section. I'm trying to figure out why my friends 770 bh dipper piston keeps bending. She has used the tractor plenty but recently has been destroying the pistons. The first one bent slightly, the second one turned into an S shape and the third has a 45 degree...

Just saw this on Craigslist. I'm do not know know the seller. Thought someone might be able to use it. 1300 for sale

Does anyone know how to remove the short PTO shaft that runs through the rear axle case? It is number 45 in the picture. I'm trying to separate it at the collar (number 43). There are no visible lock rings outside of the collar. It looks as though there may be a snap ring inside the collar...

Hi All, New to the site although I've been reading the Yanmar posts for a while. I wanted to say hi and share a few modifications that I have done to my 1500D. I now have a 105 amp alternator on the tractor. This allows me to run the 55 watt off road bulbs that I have installed in the...