Search results

I just saw that Kubota introduced the new BX-80 line of tractors. They say the loader and backhoe can be changed without getting off the tractor....no pins no problems??? I went to their web site but they still have the old BX line up there. I really want to see how this new mounting system...

I have been looking at a King Kutter 48" tiller for the BX25 and they make a XB and a TG in the 48" width. They say for a sub-compact tractor that I need to go with the XB Limited CAT 1 unit, but it looks like some folks on here are using the regular CAT 1 units on their BX with no problems. I...

I was looking at wood chippers for my BX25 and thought I was going to get one of those Chinese units brand new. I was about to pull the trigger when I noticed a word of advise about checking to see if your tractor would lift it. I never thought about that. The weight of these things was 950lbs...

I have been looking at getting a wood chipper for the BX and I know I am on the low side of HP for these guys, but now I am looking at the weight of the units. Most decent chippers seem to be around 950 pounds and if I read it correctly the BX only lifts 670lbs with the 3 point. Has anybody...

OK I have had my BX25 for a little over a year and have not installed the 3 point hitch kit that I bought to go with it. I still have not purchased that tiller for the thing. My question is....do you have to remove any of the hitch kit to put the backhoe back on? I am a little confused on that...

The dipstick on my BX is different than the one it shows in the owners manual. I find it strange that they would change it this much and not mention it. My ZT Mower has a Bota 3 cylinder diesel and it is more like the one in the manual. There are 2 holes about two inches apart and it seems like...

I was cutting grass and needed to raise the front bucket to clear a fence and it would not go up. All other functions of the loaded worked but up. I pulled off the screen panel so I could see the linkage and when I did a nut fell out. I saw one of the threaded shafts at the linkage rods was...

I know UDT (20w) is single weight and Super UDT is (10w20) multi-viscosity. By accident I put UDT in my tranny instead of super. Is this a big problem? :confused3:

Anybody got a good DIY on a valve adjustment on a Kubota 3 cylinder. I have a 21.5 hp diesel in my Hustler Zero turn that has a lot of clatter and I have never adjusted the valves.

OK, I have a BX25 I just got this summer and I notice that there are these "O" rings that are just breaking on several hydraulic cylinders. Are these just protective rings for the painting of the tractor or do I have a problem here?

I have a whopping 20 hours on my BX25 and have developed a leak at one of the fittings on my back hoe. It is down at the swing piviot and is marked with red tape. I figure it is metric,but can't find a wrench to fit it. Out of 3 open/box wrench sets I have.....not one has a 18mm and it appears...

OK I am the new owner of a BX25 and now have about 8 hours on it. I was wondering if it is normal for the backhoe to sag down to the ground from its fully retracted position over the period of a couple days? I could see it on an older model, but would think a new "tight" unit would hold...

Hello folks....new here. I just sold my Farmall A last night and am taking delivery on a BX25 tomorrow morning. I was wondering if there are recommendations for a thumb for the BX BH?