Search results

Hey all, I hope this it a quick question. I started hearing a noise from the Transmission, long story short, it ended up being the lock plate in the left axle that holds the planet pinion carrier to the axle shaft. the gears chewed it up to just slivers. It looks like the short axle stub...

Hey Guys, I'm hoping this is any easy question. I Split my tractor between the clutch and transmission housing to replace the 10 pto clutch disks and separator plates. Rebuilt the pto clutch and reinstalled it back into the tractor. I slide the tractor back together tightened up the case...

Hey all, The twine disc on one of my knotted is worn out. Went to the dealer and they gave me a disc with 3 disc on it instead of 2, they said it is the update version, got 2 cleaners and a new holder with it too. Drove home, an hour a way, I went to install the disc to find out the pin...

Good evening all, I got the old 1010 from the old homestead, she is really in bad shape. I figure I would get tires back on her so I can move her around the shop. One tire is completely rusted way, only the power bars that were on the rims are left. The other rim is rusted but could...

Good morning all, I though my clutch was worn out, there was too much play in the petal. the gears would not stop turning when the clutch was engaged, but the linkage/rod from the pedal to the throwout bearing lever was tightened all the way. although the clutch was not slipping. so I split...

Good morning all, I have 4 feet of fresh snow on the ground that needs to be moved and it was -11 at 5 this morning. It is just a little to cold for the old girl to start on her own. it has a cold weather starting kit on it. I have never used it and it shows it age. How does this system...

Hi All, I dug into the rear left axle because it was leaking fluid. (also fixing the oil leak on Load Control for the 3pt) I have new seal, bearing and cups on order. but while tearing it down I noticed a lot of play in and out about 1/2in. the inside bearing is worn and pitted up, including...

Good afternoon all, I just picked up a 14six loader for my 2240. It came without the valve. I think I have settled on a prince 3 spool valve with a joystick (2) and 1 for a grapple or angle blade. the Boom also has a float. the valve has a max of 2five gpm. I will get the close center...

Good morning all, I'm rebuilding my pole barn that collapsed under the snow load last winter. I have a question about how to secure the top girt that the trusses will be setting on. I'm using 6x6 posts and 2- 2x10 x16 girts sandwiching the post. the post are 8 feet apart. I have 2 posts per...