Search results

I have a shave hd8 post driver that I want to convert from a 3pt hitch to a quick attach style mount. My question is about the hydraulics. I planning on using it on a jd 110 tlb with the flat face aux hook ups on the fel. Is it possible to operated the post driver off these hydraulics and if so...

I recently purchased Kubota M9540 with a cab. I am having trouble with the heat in the cab blowing cold air. I have checked the damper door under the seat that diverts the air from hot to cold and it seems to be working correctly. Any suggestions on what else it could be.

I replaced the loader valve on my jd 2550 with a prince valve and am having problems with the bucket raising up as the tractor runs. It is not very fast but over a few minutes it has raised up quite a bit. It is a closed hydraulic system so I put a cc plug in the valve and have tried to adjust...

I am looking at getting a used vermeer cx224 excavator but I don't know anyone that runs Vermeer equipment. Does anyone have any comments about Vermeer excavators good or bad. Also who makes them for Vermeer, I have heard that kubota makes them but can't seem to find that written anywhere. Any...

I have a John Deere 2550 tractor with a 175 JD loader on it. It has recently develpoed a problem with lift cylinders drifting down, even with the tractor running. I had the lift cylinders rebuilt and I have also replaces the cables that go from the joystick to the valve that is located on the...

I have a '02 Bobcat 337 excavator that ras developed an electrical problem when I try to start it. After the heat cycle when i try to crank it, all it does is click like the battery is dead and the battery warning light comes on. I pulled the battery out and tested it and it read that it was...

Does anyone have a good source for a service manual for an L35 Kubota? Either a downloadable or book would be fine. I was trying to find one cheaper than the dealer if possible. I am also looking for a hydraulic diagram for this tractor and am not sure if this is in the service manual or not...

I am fairly new to hydraulics but am learning a lot through this forum, so any help would be appreciated. I am going to add a set of remotes to the rear of my L35 and have a valve that I want to mount beside of the FEL control. I am trying to figure out the best way to tap into for the in port...

I am fairly new to hydraulics but am learning a lot through this forum, so any help would be appreciated. I am going to add a set of remotes to the rear of my L35 and have a valve that I want to mount beside of the FEL control. I am trying to figure out the best way to tap into for the in port...