Search results

I have a Bolens G154/ISEKI TX1300F that all of the sudden kept going forward when I depressed the clutch while I'm using my brushhog (internal over running clutch messed up?). It's never done this before. Is there an adjustment that needs to be tinkered with to make it work again? I'm not 100%...

Yesterday, while getting my riding mower off my trailer (I was getting ready to take my tractor and brush hog to a lady friend's place. Whole different story), something hug up while the mower was on the ramps. "No big deal!" I thought. I pulled forward to get some momentum backwards to bump...

A few years back, I bought a Bolens G-154 without a front end loader for $2000 with a brush hog. It had only 315 hours on the thing. Since I bought the tractor, I've been looking for a front end loader. I recently found and bought a G-154 with a loader, but the loader isn't attached. I've looked...

I'm looking for one to use a hay spear, scoop cattle manure, and pulling farm implements with on 100+ acres of land. I have a small (15hp) tractor, but I've discovered it's not enough for some dirty deeds.

How large are they from front to rear, side by side? I'm picking up four, and I need to know if they'll fit in the bed of a shortbed 3/4 ton truck. Thanks in advance! (I'd rather not do two trips as they're a five and a half hour drive, one way)

Anyone know what the proper size battery is for a Bolens G-154/Iseki 1300F? The reason I'm posting this question here and not the Iseki forum is the last time I posted a question in the Iseki forum, it was two years before anyone replied, and that person was me.

a voltage regulator for a Bolens G-154? Three cylinder diesel, 12V Neg Ground.

My mother has several acres that we used to have cattle on. Now, because it's just her on the property, there's no animals. She likes to go into the pasture and pick blackberries and pears. The problem is, the cattle left the ground diveted with hoof prints here and there, especially where my...

Does anyone know where I can buy feeder corn for cattle on-line? I haven't had much luck locally or on-line. Thanks in advance! :)

I've always been one to take responsibility for my action, especially when I step on my third appendage... I would like to extend my sincerest apology to anyone who was offended by my post where I had a picture of myself comparing it to two pictures of the leader of the Hezbollah. A friend...

I apologize for not putting this in the other post.... If you live off grid, what do you do about phone service. In both situations, I'm looking at a piece of land that there is no electricity or phone service for at least five miles. I'm looking at how practical owning and living on that...

I have a questions that's been begging me for an answer. Of those of you who live off grid, how is your frig, sterio, freezer, shop equipment, et al powered? Do you buy DC appliances or run everything through converters? How about larger load machines like air conditioning, furnances...

What's the pros and cons of both? Why pick one over the other?

What implement seem to bring rocks up to the surface more than others? After the rocks come up, what do you use to remove them from your garden?

I'm trying to find out if I can order a slipclutch for their RTR0542 rototillers. When I bought the tiller, the salesman said it comes with a shearpin only. No slipclutch is available for it because the PTO shaft is too short. That doesn't make sense to me.

My neighbor came over and told me where I was tilling was a bad place to put a garden because that's where she and her husband put rocks over the drainfield! I would have gotten a clutch type PTO, but my ag dealer told me it wasn't available for the tiller (Landpride RTR05) I was buying. The...

I have a Bolens/Iseki G-154/TX 1504. Does anyone know what the lift capability of the three point hitch is? Thanks in advance!

My daughter told me this joke after asking me why I always leave the seat up. How is a tracltor like a toilet? You leave the seat up so you don't get your butt wet when you sit.

Seems this commercial hasn't made it's route yet. I caught it and darned near laughed myself to the floor! http://media.ejbdotcom.net/de2d6e/vaultenergydrink.wmv My daughters said they could see me doing something like this!

I took my truck to the local Jiffy Lube because. over here, it's a royal pain in the butt to dispose of used oil. If you take the oil to someplace that has a barrel for recyling, it's usually full, and you get soaked in the backsplash. At any rate, while my truck was getting serviced, I asked if...

I'm in the market for a tiller for my tractor. It's a little 15 hp Bolens/Iseki 4x4, weighing in around 1200lbs. I called around to find most of the 40-42 inch tillers in my area are running between $1300-$1500. The local Kobota dealer has a Landpride reverse roation tiller for what looks like a...

What\'s the best way to spread fertilizer? I have some 64-0-0 and was wondering if a regular spreader is good enough or if disolving it in water and spraying it is better.

I have a Bolens made by Iseki TX 1504 (G154). When I bought it, it did not have hydraulic controls, loader, or anything else that is hydrauliclly controlled. I would like to change that. What will I need to add hydraulics to my baby? What kind of $$$ will I be looking at to add hydraulic controls?

Does anyone know where I can get booms and sprayer nozzles so I can build my own? Can I make due with pipe and attach hoses to the pipe, or will I have to run the liquid through pipe? I built a carryall that I'm carrying my tank and wand sprayer with. I'd like to put booms on the carryall so I...

I have to ask because I'm ready to leave the wet side of this state, and buy 100 or so acres in Eastern Washington. I hate the faster pace of life and neighbors who stare with blank looks when you wave at them over here. Over here, everyone seems too busy to give a hand to another who is in...

http://earth.google.com/ I've been looking for some land to buy where I can tear up motherearth with my tractor. When I find it on-line, I check it out with the Google Earth program to save unnecessary trips out of area. Good thing too! Once place that was 100 acres for $80,000 was on the side...

I was wondering what you guys use to plug your electric sprayer motors, lights, et al into your tractor's electrical system with. I was considering a 12V utility plug (cigarette ligher adapter), but came across what's called a forklift plug (Anderson connector)...

How deep are they supposed to be buried? I was tearing up my front yard to reseed when I pulled up the repair from the last time I pulled up and ripped my telephone cable. Last time, I set my subsoiler to about two feet. This time, I was only going about a foot when I found the cable (again). I...

If you could design the box scraper of your dreams, what would you have as features? Trapaziod sides? With skid style side bottoms or without? What kind of scarifier attaching device? Bolts? Pins? Notched scarifier with wedges to secure the scarifier to the box? Straight blade? Curved...

Last week, my tach stopped working. I drove all over my area trying to find a replacement when I found a speedmeter repair shop that said it would be no problem making another tach cable for my Bolens/Iseki. I asked if they do mail order and they said they also do internet sales and repairs...

I have a Ivco (Southeast) made brushhog type mower. This weekend, I mowed the community cemetery. It's "self maintained" cemetery where the people who have folks buried there take care of the cemetery. I decided to do everyone a favor and clear several areas of scotchbroom (up to two inches in...

Is it possible to add caster styled wheels to a brushhog to improve the quality of the cut? My brushhog scallops the pasture here and there due to it being a little uneven. Will the extra wheels stop the scalloping or am I barking up the wrong tree? Should I ignore the problem or should I till...

It's that time of year when wasps, yellow jackets, and hornets are out and ambushing us. I told my youngest daughter to be careful as she was out planting blue berry bushes. Shortly after warning her, I hear the Shopvac running. My daughter stuck a 25 foot long piece of PVC pipe onto the end of...

Almost 30 years ago, I put a barbed wire fence up around my parent's property. Since then, the posts have fallen and the field has overgrown. I had almost forgotten about the fence until my tractor's brushhog found some. What I'm trying to figure out is how to find and remove the barbed wire...

For years, my front yard flooded every spring and fall. This year, I took baby and her new tooth into the yard dragged the new tooth through the yard. Baby and her tooth (111 KB) Just as we're almost finished tearing up the ground, baby comes to a complete stop with her wheels churning. I...

What the heck is a two point hitch system and how does it work? What does it look like and how do attachments hook up?

I have a Bolens made by Iseki TX 1504 (G154) that I bought a rototiller for. It's not a three point cat 1 type hitch typ of tiller. According to the manuals, this is the same type as what is sold by the company when new. Unfortunately, I don't have a manual that tells how to mount the tiller...