Search results

Good evening, I’ve got a hustler raptor SD that’s leaking from the parking brake shaft. I’ve seen the instructions online. But, I’m wondering if anyone has any advice in regards to jacking up the read and making the repair? Thank you!

Hello, I'm looking for an aftermarket starter for my tractor. (International 784)Can anyone recommend a good brand? DB Electical? EMS global? Uni Point? thank y誕ll!

Hello, I was wondering what the larger size fasteners are on a tractor. As in where are they located. I知 buying tools and would like an idea of what sizes I will come across and where they are found on any given piece of equipment. Thank you!

I have an International 784 that needs to have the power steering cylinder rebuilt. I have a couple of questions. Will the lines need to be capped off while I repack the cylinders? I'm aware that debris may enter the system if I don't. My concern is that will it continue to drain hydraulic...

I have an International 784 that needs to have the power steering cylinder rebuilt. I have a couple of questions. Will the lines need to be capped off while I repack the cylinders? I'm aware that debris may enter the system if I don't. My concern is that will it continue to drain hydraulic...

Hey folks. Ive got the material to build a middle buster. I do not however have the plow or mold board itself. I was hoping to get some pictures or dimensions for the blade mount point ie: inside width of where the blade attaches to the the ripper or flat bar in my case and how the blade is...

I have an implement for a farm tractor that weighs 1200#s. I'm building a three point hitch mount out of A36 flat bar that is 1/2x3". The flat bar has 1-1/8" holes drilled in it 1-1/2" from the back and 1-1/2" from the top and bottom for an outside edge distance if 15/16" all the way around...

I think I'm posting this in the right place...I have an implement (landplane) for a farm tractor that weighs 1200#s. I'm building a three point hitch mount out of A36 flat bar that is 1/2x3". The flat bar has 1-1/8" holes drilled in it 1-1/2" from the back and 1-1/2" from the top and bottom for...

Hey guys as the title says. I have an international 784 tractor with a cat 2 3600# lift capability. I have intend on building a grader scraper that weighs around 1100#s. my question is: do you quys think the tractor has enough ***** to pick the unit up? It is going to be a 7' unit and I've had...

Hey folks I'm changing the hydraulic oil in my 784. Are there any drain plugs aside from the two under the operator and one above the drawbar for the PTO? Also are there any tricks as far as bleeding or is there a screen separate from the filter? And where is a good place to buy air filters...

I'm getting ready to excavate an existing 200' ditch it is only 18-20" deep now and that was done with a 3 to 1 approximately 11-12' bucket. It was dug to provide drainage along a private easement. The individuals using the easement saw it as a deturant more than something that would help...

Just bought a couple of 784s. One needs a throwout bearing and master cylinder seals. The other on has a slight fuel lead coming from a line on the injector pump. Neither one of them smoke a bit. 2600 hrs on one and 3400 on the other. Any idea what these two guys should go for? Thanks for...

I'm the proud owner of two new (to me) tractors. I look forward to making new friends and influencing people