Search results

Just bought a used 2017 JD 3025E with a front end loader. Before I made the purchase I noted that the 3 point hitch arms went up and down. I asked the dealer if there were any problems with the machine and he replied in the negative. Now that I have the machine and home and going over it...

Looking at a Tajfun EGV 45A logging winch. Looking for input from other Tajfun owners. Thanks in advance for your input!!!!

Looking at buying a JD X738 4WD lawn tractor. Pros? Cons?

Looking at a Moritz dump trailer. Well built and solid. It has the torsional axle/suspension rather than the conventional axle/leaf spring system. Any experience /comments, good or bad, on the torsional system would be appreciated. Thanks, Kevin

Looking at a used 2006 JD 4720. It has fluid in tires. This 3rd owner does not know what the fluid is. He claims it is NOT calcium. No labels on the rims. If rim guard, I assume it would be labelled as it is on my JD 4520. Safe to assume it would be windshield washer fluid? The...

Looking at a used 2007 4520 with a cab. Lever to raise and lower the rockshaft arms will move only slightly. The shaft that goes into the rockshaft housing will not move/turn. The cable appears to be free and has no kinks or sharp bends. It will move. From sitting all winter could some...

Anybody know where I can buy the quick attach plates/ears to convert a pin on backhoe bucket to quick attach for my JD 110 tlb??? Thanks in advance for your assistance.

Has anyone removed the ROPS/Canopy on their machine? Does it come off easily after you unbolt it and discconect the wires? Did you lift off by hand or with a sling? Thanks.

Hi All: My brother has a 4600 and the fuel cutoff solenoid doesn't work after a number of starts. If you let it sit awhile, it will start. I have taken the solenoid out and laid in on the frame. It will pull the plunger in a few times, but then will stop. If you push the plunger in...

Looking at a 2007 JD 4720. Less than 400 hours on it. It has not been run in just over 2 years and has been kept in doors the entire time. Battery is dead. Before starting, I think I should drain fuel tank and filter and put new fuel in. Will it have lost prime sitting for 2 years...

My brother has a 4600 with over 8000 hours on it. Oil leaking from injector pump filling the fuel shutoff solenoid. Obviously a seal leaking in the injector pump. Based on research of other posts, it appears that a rebuild is necessary. Is this a quick/inexpensive repair? Any advice...

Hi Guys: Read all the previous threads about pin on hydraulic thumbs. Tried to e-mail Northsaw but it got bounced back. Who makes the one for DEERE? Any others you can recommend? Thanks for your assistance. KRH

Looked at a used JD 110 a week or so ago on a cold moring when the wind chill was below zero.. I let the machine warm up for 5 - 10 minutes before I took it out for a spin. While trying it out I stopped and started and reversed it a number of time. 2 or 3 times I pushed down on the forward...

Looking for a good used 110 with loader but without the backhoe. Thanks.

Looking for someone with a JD 49 backhoe on a 5X25 series tractor. Do you hook up all 3 hoses from your backhoe to your tractor or do you only hook 2 of the 3 hoses up to your tractor? Thanks much for the information.

I have a JD 49 backhoe mounted on a JD5225 and it's performance is disappointing to say the least. Only one cyclinder will operate at a time. It is just like my old pto pump operated 3 point hitch backhoe. Raising the RPMs only makes the one cylinder operate faster and with more pressure. On...

Looking at 5225 with power reverser. Any issues/problems with this set up. Thanks. KRH

Looking for a hood to fit the John Deere 5300

Been reading this informative site for for quite some time and have learned a lot. I looked at a used John Deere 5300 4X4(no FEL) with some 3500+ hours on it. It's been really used. Lots of brush hogging!!! The pto will not disengage. I tried everything. I crawled under it and the...