Search results

Grease fittings pulling out of the anti-scapl rollers. Purchased a New RCK60-29b a few weeks ago. Now on my 3-4 grease job only to find that the fittings are pulling out. They are not threaded, they are ribbed and pressed into the PLASTIC wheel hub. Will be seeing my MB Tractor Kubota dealer...

I have a kubota B2320 with a LA304FL loader. I plan to equip the loader with a Tach All quick hitch adapter. Will this create a problem in taking the FEL off/on?

Kubota’s B & BX Series tractor seat issue is a complete disaster. This information is long overdue. My business takes me to all of New England. From time to time during the past year and a half I have stopped into numerous Kubota dealerships to express my displeasure over my B7510 seat. Each...

QUESTION…I have a B7510 with 50 hours. The maintenance schedule reflects that the transmission fluid be changed at 300 hrs; however, it reads that the transmission strainer (metal strainer 26 mm head) be cleaned at 50 hrs. How much fluid is lost during the removal of the strainer? I want to...

BELIEVE THIS… Upon searching a number of web sites for a power collection unit of grass clippings and fall leaves in conjunction with my tractor I came across the Cyclone Rake Company www.cyclonerake.com. As I viewed their site I noticed a swivel wheel and tire as a listed part, which appeared...

implement-ML-858033-ML- Thread about an attachment

I’m contemplating between the 6 or so HP gasoline engine type vac/blower or the PTO type vac/blower unit for sucking up the grass cuttings and the fall leaves with my B7510, which is 21 HP with a rear PTO of 16 HP.. Have not had any experience in either. In reading the postings I would say that...

I’m contemplating between the 6 or so PH gasoline engine type vac/blower or the PTO type vac/blower unit for sucking up the grass cuttings and the fall leaves with my B7510, which is 21 HP with a rear PTO of 16 HP.. Have not had any experience in either. In reading the postings I would say that...

Purchased a Kubota mmm RCK6024B last summer along with my B7510 and FEL (LA3302) I mowed through the summer with the mmm, however, was not really happy with the way it was cutting. The center rear dual wheels which set side by side on about an 8 inch horizontal shaft seems to carry a lot of...

When I first serviced my B7200 HST in 1987 I found the Suction Metal Strainer (Hydraulic system bolt type strainer) containing rather a large quanity of metal filings that were obviously left in the engine etc. Now I have a B7510 with 30 hours... If I were to remove and clean the metal...

The engine oil in a new Kubota Tractor: Is it; A) A special break-in oil that needs to remain in the tractor for its first 50 hours. B) A regular type oil that could be charged at the first 25 hours then again at 50 total hours, just to...

Anyone experiencing sudden surges during slow acceleration “takeoff”particularly in high range at any RPM? The surge is very jerkiness and annoying. Also while moving along with steady acceleration the tractor feels like it went into passing gear and the ground speed increases. Tks in advance

Any idea for a good shop repair manual for KUBOTA B7510? Thanks in advamce for your replies.

I recently purchased a new B7510 Hydro. When I attempt to accelerate slowly in HIGH the tractor moves slowly at first and then it suddenly jumps forward like someone had struck you from behind. Like a jackrabbit start. It will do this eight out of ten starts, at any RPM. Same for in reverse...