Search results

Recently when operating the tractor I heard a loud pop or bang and then lost 4WD capability. Troubleshooting, I disconnected the 4WD rod assembly, from the 4WD shift lever to the Arm Plate Comp mechanism on the transmission. With the tractor raised off the ground and running in low gear, I...

I am about to go with the non-original equipment oil filter on my 4110, when cross referencing the Original Equipment oil filter part no. 14501673991 to Fram, it recommentds PH16 and WIX states 51381. Has anyone used these cross reference filters? Any issues? What other non-original equipment...

I have a 2005 with 1130 hours on the clock. Purchased new and other than scheduled maintenance, repairs are minimum with the replacement of a few ruptured hydraulics lines and a couple of valve stems destroyed by logs, both times in the woods loosing the loaded ballast. Welded rings around the...

Arctic Cat 400 - recently fuel started pouring from the carburetor bowl drain. The drain screw was tight. I've removed the carburetor and cleaned the bowl, but with the drain screw secured fuel continues to pour from the overflow. The float appears to be operating normal. What would cause the...

While changing the engine oil at its scheduled interval, while first draining I heard something hit the bottom of the oil bucket, which I thought it was the drain plug washer and immediately fetched out and discovered it was a gear tooth. A small beveled gear tooth. What would cause an engine...

I changed the hydraulic fluid and filters today and discovered the canister O ring was broken from the last changed performed by a dealer. Due to leaks, I will need to redo and replace the canister O ring. If I open the canister to replace the O ring, will I loose all the fluid or just what is...

I need to replace a few broken grease zerks and questioning are the grease zerks Metric or standard regular american thread on the 4110?

328 hrs and faced with my first problem and hope I can get some direction on repair. At the bottom of the 509-backhoe boom at the swing post, there is a small quarter inch hose, which I assume is a hydraulic pressure release for the valve assembly. It痴 continuously releasing hydraulic fluid...

This article was in this morning's paper, the Rutland Herald (Rutland Vermont). June 14, 2007 Staff Reports and Associcated Press State Police investigate the scene of an accident with a hay baler Wednesday evening at a farm on Route 3 in Pittsford. PITTSFORD — A 16-year-old boy...

Currently I am preparing the structure in preparation of installing western red cedar clapboard as exterior siding at the weekend place. I was planning on keeping the clapboards natural and sealed with Sikkens Cetol SRD Sikkens: Simply Beautiful Woodcare Products For Your Wood Home Clapboard...

I have a Craftsman 18HP garden tractor with a DOHC Twin Cylinder Briggs & Stratton engine which is running rough. This week the tractor ran fine during the first few hours of operation, but when using the following day, the tractor stalls when fully opening the choke and now will only operate...

Hi... I’m in the market for a Cat 1, PTO powered, 3 point hitch broadcast spreader capable of spreading sand during winter conditions. I’m familiar with the clogging problems that occur with frozen sand and fine dry sand is preferred when using a broadcast spreader. My tractor is stored in a...

Hi Folks, New guy here as far as postings, but monitor discussions daily, which I find interesting and helpful. Here is my world. I am in the process of building a second home in the mountains of Vermont, what can go wrong has and recently got shut down by winter conditions. (Unfortunately I...