Search results

Can anyone tell me how long this rear blade is? I need to know the length from where it attaches to the 3 point arms, to the end of the unit. Trying to determine if it will fit in my shed attached. It will go on a Kubota BX-23. Thanks!

I just installed my Tiny-Tach diesel tach and have a question. In light of all the "fast idle, engine life, etc" debate here, I was curious about my rpms, but puzzled by my BX23 readings. At the lowest throttle setting, the RPMs show 1280. At the fastest setting, it shows 3390 rpm. Since the...

BX23 Temperature gauge - what\'s a normal range? I've only had my BX 23 for a month or so, and I've not seen the temperature gauge go more than a 1/4 to 1/2" from the lowest setting. Is this normal? Other than two mowings in late October, the rest of the 20 hours or so have been with FEL...

Well, somewhat tractor related as the loader will be used to load the soil! Anyway, I'm looking for ideas for a small topsoil screener. I've got about 20 yards of excavated earth (and more later) that I want to screen. There are chunks of grass and rocks in the mix. Has anyone come up with a...

Does anyone know where you might be able to rent utility trailers in North East MA? Most of the tool rental places no longer rent trailers due to the liability. I have occasional need for a 16' trailer to move my CUT. I would buy one, except that I have no place to store it. Renting is my best...

I'm new to my BX23 and have a question on 4WD. I presume there is no mid or front differential, so I can expect binding on the wheels when turning on firm ground, etc. While using it on dirt or grass, I notice that unless I am travelling in an absolute straight line, I can feel some slight...

I only got my BX23/mower recently and was putting the mower away this weekend. I noticed that there is only 1 leading edge reinforcement strip, under the left side of the deck. There is no strip under the right side. even though there appears to be mounting holes on the deck lip. The manual...

Open to suggestions for best way to mount a couple of lights on the ROPS without drilling holes. I've seen solutions that utilized C-clamps that clamps a bar with the lights onto it. Would love to see other elegant solutions that members here have improvised. Pictures appreciated. Thanks!

On my old lawn tractor, the underside of the deck and blades gets pretty torn up when when I use it to clean up/collect the debris after dethatching with tines. The sand in the grass that is pulled out is like sandpaper. Since I have a shiny new 60" MMM, I'm kinda reluctant to subject it to that...

Thought that would get your attention! But seriously, when my mower (60" MM on BX23) is at it's fully retracted setting and I go over bumpy ground, it kinda rattles up and down a bit on one side. Is this normal, or should I look to adjust it? It came from the dealer with the cutting height...

Former lurker, but am now a proud owner of a new BX23 (arrival pic attached), so have registered. This is a great resource. And here's my first question already. I got around to checking levels and it seems that the hydraulic oil level is low. The manual says to check levels with implements...