Search results

fused red wire to solenoid blowing 25 amp fuse when ignition turned .when fuse is replaced glow plugs can be used and as soon as ignition turned to right , pops the fuse .

Red fused wire to solenoid is popping fuse , is this a starter problem or is there something else causing the problem, i cannot start due to the problem . The fuse is fine to use for glow plugs but is blown as soon as the key is turned . thanks in advance

The starter is not engaging completly all the time , it is grinding the flywheel .It has been cold -15 celcius or so but is indoors . It sounds like the the gear is not being thrown out far enough. I believe it is the bendix? My brother mentioned to lube the shaft but i always thought that just...

03 hydro suction screen magnets are not present in the pre filter of trans . My service manual shows them and states "magnets " meaning 2 i suspect . My dealer shows nothing in his parts book and wondering if these magnets are ptresent in all 4400 - 4600 on and on . I would appreciate some...

when in forward i notice a surge when travelling , this condition exists when pedal is matted , the travel seems fine in and around at part pedal application . Is this an adjustment or operating build of the hydro trans. i am only used to a pwr reverser trans . Could this also be a pump problem .

i thought i would ask if the bleeding down of the stabilizer is the fault of a stabilizer seal on the cylinder or a spool on the b/h levers. It is not weeping any hyd, fluid at the stabilizer cylinder and i cannot see into the spool area . Just thought i would ask if the problem can be easilly...

the tractor has 783 hours and was bought used , the dealer needed to put 2 new pumps on it before i picked it up - problem was weak hydrolics. Are these pumps a problem ? . the other question was the right stabilizer leaks down. It does not seem to leak .

recommend backhoe for the 4600 please post pics and your views on the best back hoe for this tractor . thanks

am i to use 85-90 in the front axle or hydrollic fluid , it is slightly low and would like to top up. thanks in advance

i was hoping to entice a discussion on the shimming of these hydraulic pumps , and is this a common shop item that should be dealt with - if so i would appreciate an education in the process . I notice in a prior post the third manifold in the pump is the work zone to be shimmed . I currently...

i noticed on the install of the loader 2 items i would appreciate some discussion . #1 - the cylinders for the unit are a black colored steel - in the past i notice4d all cylinders to be chrome . #2 the pins on the unit are plastic - almost all of them except for a couple - these others seem to...

The tractor has a shift assembly on the right fender , that is cable operated , the cable routes into it looks to be the hydrollic manifold for the front bucket. It is a little stiff also. What is the function of this lever and cable? Also can i just use a good quality hydrollic fluid in the...

could any7one provide me with a downloadable owners manual for the 2001 - 4600 series JD . I bought from a company and unable to provide me with the book. I bought a tech manual cd and a parts manual , but did not purchase the owners manual becuase of the first 30- minutes used and on the shelf...

just purchased a 4600 with 2000 hrs , any problems i should be aware of - sold solid little kubota L2250 for this and it is definately more product . The loader is a 400 cx and has a quick tach on the 3 point . So lets discuss the japanese motor in this machine - weak points? i noticed the draw...