Search results

Im bringing a 1958 MF 202 with a loader back to life. After finding some valves stuck open and having the head redone Im now faced with getting some of the lifters unstuck. Penetrating fluid and tapping the lifters down has worked on all but three of the stuck lifters. Im making sure that the...

Operated the tractor yesterday, today it won't crank over. ran a jumper wire from the starter solenoid and it cranks find so the battery and starter are good. What should I look for next?

My 59 641 turns much sharper left than it does to the right. The toe in is correct. It appears the sectors are not aligned correctly. Short of removing the steering is there a way to match them

I have a 59 MF-65 diesel with power adjustable rear rims. I'm pretty sure they are not the originals because the rails are different on one side. A little research shows these were popular in the late 50's and 60's on many tractors. The clamp lock is drilled differently on the rims I have and...

Im changing the cutting drum bearings on my JD 25A. There are grease fittings on the 4 bolt bearing housing but both bearings I removed were sealed bearings. This is an older mower so they're probably not original. My local JD shop is totally unfamiliar with flail mowers (northern NM). The...

I'm working on a B8200 for friend. Would not start. The starter was shot, like it got jammed in the flywheel and "cooked" it. He got me a new starter so I bench tested first successfully. Once installed it wont start from the key switch. Tried jumping the solenoid and it engages and turns...

I've been having trouble with my FEL since reinstalling it. The boom would lift extremly slow, if at all. After replacing the diverter valve and then the selector valves I finally found the problem. The right side cylinder was bent. The boom cylinder looks to be 2" ID and about 42 inches...

Ready to start seriously looking for a PTO pump for the FEL on my MF-65. I'll also be replacing the valves (due to a small crack) and adding QDs. So the question is how many GPM do I want? Tractor has 40+ HP at the PTO and is diesel.

Reinstalling the front end loader on my 59 MF-65 diesel. When hooking up and bleeding the lift arm cylinders I had some problems. Im using the tractor internal hydraulics with I believe is the factory diverter mounter under the seat. I have the 3 point section lever in the center position and...

My Vemco T72HD flail mower had a cutter shaft bearing failure. I used it about 10 hrs since getting it, greasing the bearings 4 times during this period. The right side (away from the pulleys) is what failed. Pulley side is still good. During disassembly I noted the housing for the failed...

I'm trying to sort out if I have the right tach cable hookup for a block connected tach drive on a 1959 MF65 Diesel. Pictures show the cable end, the drive gear inside and the block connection. It seems I'm missing a piece to connect the cable to the drive. My closest Agco dealer has been...

I found a pdf of a diesel mf65 online. On page 38 it says the reservoir holds 3.5 pints of Type A ATF. On page 3 it shows the reservoir in front of the fuel tank and behind the air filter. My tractor doesn't have this reservoir. It just has a plug on the top of the pump. Anybody else have...

Just picked up a MF-65X for $3k with a front loader and box blade. Starts and runs well but needs some TLC. The serial number is SNM 668305. What year? Chuck