Search results

Hello, I'm dealing with a constant electrical draw that is killing my 2005 TC24 battery. Was hoping I could get some opinions on what is normal vs not. I have the operators manual with a wiring diagram so I know what wires are going where. Here is what I have done so far and the result. 1)...

Hello, I need to replace a couple of the small rubber hose unions in the oil cooler lines on my TC24. The OEM part number is SBA340693240. Hoping to avoid paying $25 each for 3" of line. Any advice on an alternative replacement would be great. Thanks, Jon

I have a 6" Jinma chipper and have big problems with blade to anvil clearance. I also have problems with blade to housing clearance. The problem is I have no clearance. The blades hit the rear housing it spots and the anvil on every pass. These problems started after about 15 minutes of use. I...

I have a 54" bucket on my B20. I did a search but couldn't find anyone who had built a tooth bar out of a 3/4" thick cutting edge. I know the edge is overkill but I got it for free. My question is whether the standard teeth I've seen on Ebay etc. would work or if the cutting edge is just too...

I was wondering if anyone had any first hand experience with a rottary cutter on a B20. It has 20hp with 13.5 at the PTO. From all the reading I have done here it would seem that my best option would be a 48" model. From what I have seen, 48" rotary cutters seem to all be light duty w/ a shear...

I have found a used John Deere rotary cutter. It is a model 403. I haven't really found much info. about this model. Is anyone familiar with this model? Is it an entry level piece? Any ideas on the new price on a comparable unit? It appears to be in decent shape but I would need to buy a drive...