Search results

Recently purchased a used 3pt post hole attachment, at auction; it has a logo referencing Green Manufacturing, in Bowling Green. PTO shaft says 53" compressed metric (6 spline on tractor end, smooth/round bore on implement end, with a roll pin shear pin and a set screw on implement yoke. Since...

Have 18.4 x 30's on Dad's 2640 right now, but tires are showing small cracks on sidewalls, and are likely from 1980's era, so would like to replace, with decent used, if I can find some. Inner axle bolt pattern is 8 bolts, on 9.5" diameter 'hub', outer wheel edge has 9 bolt pattern, on approx...

Anyone else have a JD 2640 and know where the starter relay is actually located? I have the tech manual, but the one pic it has for this is grainy and has an arrow pointing to (upper corner under the right cowl) what I've confirmed is actually the voltage regulator (which is square -- the relay...

A few years ago, I picked up a John Deere 494A planter, along with a number of metal planter plates. Fertilizer bins are shot, but seed bins seem fine, albeit I am a bit fuzzy how the planter plates exactly should install in the seed bin base -- bins fold up, plates fit underneath, however there...

Hi Guys, recently inherited my Dad's JD 2640. Have been having to jump start it; suspected very poor batteries (has 2), but now am not so sure. Topped off water in each cell of both batteries (almost 1 cup in each cell!), and they seemed to respond very well to recharging (bank reads now 13.6v...

Am I mis-remembering or did some Troy model tillers have the ability to switch between forward and reverse rotation of tines? If this was an option, does anyone recall which model(s) had this ability?

Looking for advice/comparisons of older 6HP vs 8HP Horse tillers -- does the extra 2HP make a big difference with larger gardens (may do 2500 sqft this year) and/or rocky or clay soil? Other factors: 6HP is a Tecumseh, comes with hiller 8HP is a Kohler, w/electric start; (and would be $150...