Search results

Recently acquired an old brown tree cutter and trying to see if anyone has seen a online parts manual. Going to probably need gearbox seals, springs, tailwheel bushings. etc. model is 80TC72 Also, gearbox mount has some sort of rubber washers for impact dampening, I guess.. Thanks! Bryant

On my high flow skid steer I have the large 1" quick connects. Yesterday I removed one of the to find that a reducing bushing was used to connect the QC to tractor on both the flow and return circuits. The port coming from tractor is 1" ID and the QC itself is 1" ID but to connect the two a...

long story short... demoed a 289Cat with Cat HM315 mulcher. worked great!!! Bought used FAE UML SSL 150 (same as HM315 just older) It was setup for a 299Cat and had 1" hoses and quick connects.. replaced 1" quick connects with standard 3/4" but left 1" hoses. I also did nothing to the...

How do these hydraulic setups compare? Need one of the hydraulic gurus to help. I'd like to use a 8.0 104-1063 motor with a 100 hp gearbox with a 1:1.46 speed up ratio to produce similar results as a fixed displacement, cast steel gear motor with the following specs. The motor is rated at...

have a char lynn 2000 series motor 104-1063 with 1 1/4" keyed shaft. Its missing the key.... is it a standard key stock or do i need to go through Eaton/char lynn? never dealt with this and need a little help... thanks!

Came across a deere 616 mower deck only. Seems in good shape. Just wanted to hear thoughts on durability in brush? I have a rc81 gearbox for it..100hp

rented Xteme 72 model and it bogs down even in grass and wont maintain blade tip speed. Salesman said it was standard flow and that my 75hp cat 252B would handle it fine. I have 22GPM. It does have the direct drive piston motor but no case drain. Could there be some sort of flow control valve...

Trying to find out a good direct drive/axial piston hydraulic motor for a heavy duty brush cutter. I have already built one using motor connected to gearbox. Naturally, no manufacturer wants to share this info. I have a bush hog 672 that Id like to put a direct drive motor on. Anyone got some...

Trying to find out a good direct drive/axial piston hydraulic motor for a heavy duty brush cutter. I have already built one using motor connected to gearbox. Naturally, no manufacturer wants to share this info. I have a bush hog 672 that Id like to put a direct drive motor on. Anyone got some...

Trying to find out a good direct drive hydraulic motor for a heavy duty brush cutter. I have already built one using motor connected to gearbox. Naturally, no one wants to share this info. I have a bush hog 672 that Id like to put a direct drive motor on. Anyone got some ideas?

Working on a brush cutter project and need to decide on a hydraulic motor. I need a motor that will provide comparable torque to the pto of a 80-150 hp tractor at 540 rpm. Can anyone come up with a torque range in inch lbs or ft lbs?

Thinking about going to look at a older modern commando. Can someone send a few pictures of theirs before I make the trip? Thanks!