Search results

I just thought I would post some information if any of you out there get a fault code 11 and the tractor stops moving in either direction. If you unplug any of the following sensors (MFWD, flywheel, forward potentiometer, reverse potentiometer, TPS) and check the voltage from the orange to the...

I am attempting to install the factory diverter kit LVB25087 onto my 4410 which already has the 3rd SCV lines installed. I've run into a problem where the new hard lines that run to the diverter valve assembly from the SCV valve crash into the hard lines for the 3rd SCV at the valve. I can't...

I recently purchased a used Befco GRT-258 overseeder, and the seed cup "flutes" are made of plastic and pretty chewed up (some of the flutes are missing, etc.) I wanted to purchase replacements, but I am having a hard time finding parts. The seed cup assemblies are made by Breviglieri, and...

I have a 4410 with a 430 loader and recently the loader control lever has become "sticky" when using the bucket curl function. The lever does not naturally return to center during curling, but does on the up and down loader function. What makes the lever return to center on the valve? Is...

I am thinking of adding a power dump to my JD Gator using an electric screw jack such as this one -> Bully 12 Volt Electric Car Jack - JEGS I am planning on welding a round pipe to each end of the screw jack, and adding a shaft to each of the pipes, one attached to the gator and one to the bed...

I currently have a set of floating forks that I am going to adapt to fit the JD QA brackets on my 430 loader. However, since the QA brackets on the factory bucket seem to lean forward about 20 degrees from being perpendicular (90 degrees) to the ground, I assumed I would also have to do the...

Does anyone have the actual specifications of the 430 loader? I've seen the following listed, but i'm not sure if the maximum lift capacity listed is at the pivot point, or measured forward of the pivot point (usually 19.5")? 430 Loader (For 990, 4300-4400 and 4310-4410 Tractors) 61" (1550...

I am thinking about getting a Pro-Aire aerator from Bishop Enterprises, specifically the Pro-Aire 36" 3pt. Does anyone have one and can post some pictures of how the tines are attached, if the tine wheels have grease fittings, and how many tines are on each wheel. Any information is appreciated

Does anyone know if the wheels and tires from a Kubota BX2200, BX23, or BX24 fit onto a 2310? The tires look to be the same size, but I am not sure about the wheel's lug pattern and back spacing. It is much easier to locate replacements on the Kubota side of things than the MF.

Does anyone know if the 2300/2310 FEL (2350) shares the same attachment pin sizes and locations as any other loaders? I'm interested in purchasing an ATI pallet fork attachment for my loader, but they don't list it as a fitment option. Currently, I'm not sure if I will only buy the pallet fork...