Search results

Got these scraps on nearly every bale knot today. First time baling, just curious if they are preventable? Knots seemed unharmed and bales were fine. New Holland 276 baler and Tytan 9000 sisal. Thank you all for any explanation or suggestions or information! (the silver is tape to hold it...

Going over a new to me 276. On the twine finger lever (part #66188) there is one spring (part # 143224). It sure looks to me like there should be two? Searching images I see one and two? There seems to be an identical attachment point for another. Parts diagrams I have found list part but...

Hi all. Does anyone running a drum mower for hay use a slip clutch coupler or an overrunning clutch for PTO/tractor protection? I'm a bit leery using nothing, no hole for a shear pin. I am worried about PTO brake as I understand it takes a drum mower a while to spin down. Any thoughts or...

Good Afternoon All, In the near, warmer, future I intend to clean out my diesel/water separator. I have read quite a bit on here about the difficulty of bleeding the fuel system after reinstalling due to unclear manual directions. I have included the directions from my 6800 manual and was...

Looking at 185 drum mower. Can't find a spec for offset in cutting position. Tractor is 84 inches outside rear tread to tread. I am trying to figure out if the 185 will extend beyond my tread in cutting position. My tractor has telescoping 3 pt arms. Would I just skew them over to cutting...

Good Afternoon, Just got a new to me RM990-3. Went over it and checked what I thought I should have, test cut for 5 minutes and parked it in barn and looked it over. I found where the belt had been making slight contact with front to back frame rail. Belt seemed to be riding low off/directed...

Hello all. Does anyone have a source for wheel spacers / hub extenders for a m6800 with stock rims? I have struck out so far with the tracks company and unverferth. Thanks.

Hi everyone. Was readying my cutter for use I found that my round stump jumper has a slight bit of up/down play in it. If I push up on the extended blade, that blade goes up and the other down. Total play on one blade tip to tip may be 1/2 inch. Stump jumper measured play 1/8 inch if that...

Good Morning, Looking at some purchase options and wondering if this is a viable set-up: L5740 4WD hst w/FEL using a 1600 lb twin spindle 8 ft pull type rotary cutter. Terrain is 40 acres, clean/cleared pasture (1-2 ft) grass, rolling hills, nothing too steep. Will the 5740 handle this, at a...

My 110 TLB has a full belly pan/skid plate. Tractor is running fine but heats up while brush hogging to about little over half on hydraulic temp gauge and essentially one half on water temp gauge. I think the pan is restricting airflow and "holding" heat. Temp gun shows about 155 F on rear...

Hello all, New member, but long time viewer. Maybe one day I'll be able to help someone as you all have helped me. We have a small place in Central Eastern Ohio. 2 horses, 2 cats, 2 grandkids and 2 tractors. My wife and I will do anything to be outside.