Search results

So I'm looking to build a fel for my mitsubishi mt160. The biggest question I have is the feasibility of crafting this out of round pipe? I have access to oil field pipe for next to nothing. Thanks.

So my mt160 has a high low gear selector and it is stuck in high gear. I can't seem to get it out of gear. I tried lubricating the selector, tried rocking the tractor a bit. It shifts fine 1-3 and R and the 3 point works fine so I don't think its the transmission. Any Ideas?

Ok 2 questions. Assuming no cost for steel. 1. I have a 5' bush hog the top is toast the gearbox is top notch. Frame kind of sketchy as well. So is it worth rebuilding into a 4'? I figure i can cut 6 inches off each side and narrow it it down. Figure length does not matter. 2. I also have a...

So I just purchased this mt160. When I test drove it everything seemed good. I knew it needed a battery and ignition switch. He supplied an ignition switch but it only has 4 poles not 5. Can I use this switch? I think I would only lose my glow plug but in the deep south winter is a joke. If I...

New to the group. Just purchased a small Mitsubishi mt 160 for taking care of my hunting lease. Look forward to learning and eventually helping others.