Search results

I replaced my 2155 tractor fluid & Filter after removing / repairing the my Rocker Shaft problem (Arms would not lower - Broken load spring and bent load link missing "C" clips). The fluid looked really good, but I was suspicious of the NAPA fluid. I bought the tractor used and replaced the...

Anyone install a block heater on kx57-4? I want to install and curious where it goes. Secondly this is my first excavator, which I bought used. Curious what the practical temperature is for operation? I'm thinking 20. I live in Palmer AK. Tks, Ken BTW I am flushing the hydraulics with napa AWS...

Hi. Since buying this, I have had intermittent periods where the rock shaft arms will not lower all the way. I would play with the load arm; however after running the rotor tiller too deep the arm is now only going full height to perhaps half. I bought the manual, but reluctant to open up. It's...

Hello. Was Brush hogging in the woods and working it hard, Lifted the Arms and then it would not go down. I had Draft control up. The tractor was slowly becoming harder to have life arms go down. Would not go down all the way with draft arm up, when I moved down and pushed down then I could get...

Hello. When my temperature sender begins to warm the resulting resistance change causes my warning lights to illuminate (low oil, hyd warn, and others). I have a black wire that is not connected near the starter in the wiring harness. I believe this needs to go to the 12V side on the starter...

Hello. I have a FWD 2155 which I recently purchased with a missing front drive shaft and bent RH/LH lift links. These parts are obsolete per JD. I'm looking calling salvage yards no luck yet. So It may be time to fabricate. Was curious if someone knew the dimensions or source to purchase the...