Search results

I am looking to replace possibly some pistons and rings in my 4720h. I contacted 2 different dealers and found the price for a set of rings on ONE cylinder at approximately $250. Read that $1,000 for a set of rings for all 4 cylinders. Pistons were about $230 each. I have never heard if these...

My newly acquired Branson 4720h has been smoking at startup and then just a bit if running at mid to higher rpms. I spoke with the Branson dealer and he thought it might be injectors. So, I tested them and did a compression check. One bad injector, one bad glow plug and the following cylinder...

Hello all. I bought an older Branson 4720H which I believe is a 2007 model. The tractor smokes a lot. Blue smoke but also white. The fellow at the shop I purchased it from (not a Branson dealer) sold it to me as is and thought it might need rings. In going through the tractor, I decided to...

I have a TYM T273 with 700 hours on it. Everything worked fine until I changed the hydro oil. I changed the oil and filter (WIX) and forgot to clean the screen. I used it to cut the grass but noticed that in high it would whine and have pedal resistance. So, I cut the grass in low. So, I tried...

I bought a 2009 TYM 233 and the PTO in not working. When I bought it, the owner had a 5' brush hog on it to show me it worked and it did!. But now at home, it does not work. The button illuminates but the lever that you push to engage is like loose, just can move back and forth real easily like...

I have an issue that has just started with my tc 33d. When I turn on the headlights, the engine dies. When I immediately turn the ignition on again all lights are off including the headlights. But, the emergency flashers work. If I wait a few minutes, turn the ignition back on sometimes the...

Hello everyone. Hope someone can help me. I recently bought a TYM 233 with the T200 loader. Loader worked good except no float. I read the thread about removing the cap and cleaning it out. I did that and foolishly reversed them and broke the cap on the outer side. I fixed with JB weld and a...

I have a TC33d that I bought used a couple of years ago. I have had the PTO gears replaced as well as the entire front axle gear/bearing/seals. It has the stock New Holland loader on it as well as supersteer. 2100 hard hours, I think. The engine runs strong, no blow by, good power. I have...

Hello everyone. I have been reading info from tractornet for years and have gotten some great information just by reading other's posts. I currently have 4 tractors: 2015 Branson 2400h, 2006 Kubota BX2350d, 2001 New Holland TC33D with supersteer, and my favorite, 1998 Ford 1720. All have...