Search results

Hi Guys, I'm in Canada, and looking for a 12mm pipe plug/drain plug socket for the 4 drain plugs on the T25 front axle. Im not a fan of using open ended crescent wrenches on hard to remove plugs, inevitably they get gauled up Looking everywhere I cant find a 12mm. I find 10mm and lots of...

Well, we had a load of snow yesterday late in the day but too late to clear it last night. Then last night /this morning it was -33C without the windchill, - 40c (-40F)with the windchill. So I got the McCormick X4.3 out to blow the snow we got yesterday (I left it plugged in overnight in the...

Hi Guys, my Gehl 2580 Round Baler ( Older baler) started breaking shear bolts today, the bolt is the shear for the pickup head. First time it sheared because I clogged the intake on the right side, ie I over fed a large clump of hay and the right side auger jammed -- My fault, but it wasn't...

Im in Near North Ontario Canada, short season here for hay , winters are long and hard with lots of snow and very cold. This past May I seeded about 8 acres with hay seed, and an oats cover crop. All growing well I dont have access to a combine to harvest the oats this fall so im looking for...

Hi Guys, Ive been using my Massey 124 Square Baler for about 8 years now and its been flawless until this year. Its equipped with a MF22 Bale thrower on the back. The thrower is driven by a series of v belts and a shaft. Basically the first belt runs from the flywheel to a pulley (with a...

Hi guys, ive been square baling for 10 years, this year I just acquired a Gehl round baler. Ive read the operator manual but cant seem to find an "clear" answer to my question which is... Once the bale informed to size and twine wrapped, ready to eject. Do I shut the PTO off to eject the bale...

Hi All, New Member here, Tractor owner for about 12 years Current Tractors are a 2011 McCormick CX100 Xtrashift and a 2018 Mccormick X4.3 With a FEL My farming is basically just hay for the horses, but recently acquired a Gehl round baler as well I run a Vermeer 3 pt disc mower, a Vermeer...

Hi guys, sharing my stupid *** mistake with you, its been a bad weekend. I sheared the cast boss off the rear axle where the 3 point hitch arm mounts on my 2011 Mccormick CX100 XtraShift (same as a Case CX100). Forgot to put the pins in the sway limiters and they're the telescoping kind...