Search results

I am trouble shooting the ignition switch and trying to trace the wire form the fuel solenoid. Could someone direct me to the location of fuel solenoid? All Farmtracs should have a similar location for the solenoid, if you don't have a 665 as a reference.

Look for approximately a 60hp, 4 x 4 Loader, rear remotes, and cab. Looking for suggestions and what it cost. Your suggestions are appreciated.

How do I set the bottom and top limit on the automatic lift control. I currently set the lower limit with the manual 3pt level. When I use the automatic lift control to raise the three point hitch it only raises about one foot instead of the full height. Am I doing something wrong?

I want to connect some Skid Steer attachments to the front-end load that requires up to 20 gpm to operate. My tractor only puts out 9.9 gpm. I am considering a 20 gallon pto pump, to run a brush cutter, post hole digger, etc. Anyone have experience with pto pump. What are the pro and...

I have a Farmtrac 665 DTC (shuttle). The clutch does not disengage fully. I have adjusted it and the tractor will not stop. The clutch does not appear to be slipping nor does it have a smell. The tractor seems to pull okay, but will not disengage. Any suggestions.

I have three and four strands of barbwire fence. The wire is all good and I want to remove the wire and roll it up. It is a good mile or more of total wire to roll up. It is nasty stuff to deal with. I am thinking about making some type of spool to put on the 3-point lift arms and rolling it...

I have an aftermarket Front End Loader on my tractor that is connected to the remotes on the rear end. I guess that would be dual remotes as it has four ports. Anyway, when I engage the remote to raise the FEL the 3-point hitch will not raise. Depending on what I am doing I need to raise the...

I see quite a lot of 3/4 inch steel fitting on tractor hydraulics. My tractor has a few. I am wondering if these fittings are recommended for high-pressure hydraulics. They appear to be more durable than the brass and stainless steel fittings. They are rated at ASTM 53. As far as I can tell...

I bought a 2004 Farmtrac 665. Frequently in a tight spot, the power steering quits working. I haven't figured out where the power steering reservoir is if there is one. Where do I fill the reservoir? And does it require Power Steering fluid or just hydraulic fluid? Thanks for any replies. It...

I recently bought a Farmtrac 6065. In front of the injector pump is a cap and a place to pour in some type of lubricant. I have a manual and it says the injector pump does not need lubricant. I would like to know what this does and what type of lubricant to use. There is no dipstick. I have...