Search results

Had a run-in with sapling on my 2665. Mashed the ft left signal. Got a new one. Rather than a simple plug at the back of the lamp assy, I get a 3 foot longish cord with bullet connectors. looks like it comes across that front frame piece that separates the upper and lower front glass. It's...

For you DIY folks, I found a set of 1/2" Ag couplers on Amazon for ~$16. Find an NPT reducer bushing, drill/ tap the inside diameter to the desired screw thread (1/4-20 sounds about right) and add a bolt, T-bolt, whatever your preference for a lower cost version...

Had in interesting experience yesterday. Was out using the tractor to finish up some culverts, moving stone with the backhoe, pushing deadwood and old logs out of the way for a shed pad, and generally tractoring around, when I looked over my shoulder to see black smoke belching from the exhaust...

I have a Mahindra 2665 that I bought with about 250 hrs on it. I notice that when cold, just after starting, the bucket curl is firm, as in I can drop the bucket down and then lower the loader and lift the ft end of the tractor off the ground. A while later, when warm, I can tilt the bucket...

I discovered some of the slop in my FEL today, seems the pins have a bow to them. The PO of this thing must have been a real genius. Anyhoo, can I just trot down to Tractor Supply and match up a new set? Or, are these specially hardened/sized factory parts? They don't look special at all, not...

I've got a 2665 with just under 300 hrs on it. The shuttle shift is extremely clunky- you have to fight it to engage, sometime it misses and grinds horribly. I've found double clutching helps to get it into gear, but it is horrible compared to my previous shuttle, a 2655, which was very smooth...

After sorting my stud situation to add my extra rear remote, I got everything bolted up tight and leak free. Mahindra has what they call a rear remote add kit, with includes the valve, fittings, levers and linkage. Everything went great until it was time to hook up the new remote. The link rod...

I'm adding a second rear remote to my Mahindra 2665, and I will need longer studs to accommodate the two valves. It's an M10-1.25 stud, and I'm looking for a 195-200mm stud to fit. So far, McMaster, Graingers, Fastener mart have all been fails. Does anyone know a source for long metric studs?

I'm chasing down a couple quirks in my FEL, wanted to double check the hose setup. The WR Long website offers little help.

Looking for a roof for a Mahindra 2665. The 6010 model also uses the same part number, 14527072204MR

Is it just the 4 visible bolts holding the roof on the 2600 series models? I want to upgrade the work lights on my 2665 to LEDs, and the connectors are inside the headliner in the cab. Roof removal seems the easiest. I see 2 up front and 2 more in the middle of the cab, just forward of the cab...

Well, not really boom, more like a very loud Pssssst! I have a 2655 cab/shuttle with 300 hrs on it. Fired it up to move a trailer around yesterday, and switched the AC on as it was warm for a change. Idled to the back of the lot to hook up, and the high pressure relief valve on the AC blew...

2655 Mahindra for sale- 55HP with loader. 300 hrs total.Shuttle shift gear model. Cab with heat, A/C, Kenwood AM/FM/Bluetooth radio. WR Long 3rd function valve. Skid steer quick disconnect bucket. 45 HP at the PTO, which is independent and button-operated from the dash. Rear tire chains...

I'm looking to add a backhoe attachment to my 2655,and have found a couple 65B units nearby. I'm told the 65B will fit my tractor, but the Mahindra site doesn't list my model anywhere in reference to compatible backhoes. Does anyone know if this unit will fit? Also, where would I go to find the...

I was checking the levels on my 2655 Gear model tractor, and noticed the fluid level was off the stick in the rear axle. The tractor has 300 hrs on it, so not quite ready for a fluid swap, but I wanted to top it off. Owner's manual references "Mahindra Universal Tractor Fluid" then says it's...

I have a 2019 2655 Cab shuttle with about 210 hrs on it. The tractor has been working great. On my last trip north (VT), I discovered the battery was dead flat, wouldn't accept a charge. I wrote it off to the cold weather and put in a new battery. Blew off the driveway and did some other timber...

Hi All, I'm looking to make my first tractor purchase, and think i have found one that will do most what I want to do with it. A 2019 2655 with FEL, cab, shuttle shift. It comes with filled tires, chains, and an 84" TPH snow blower. 160 hours. What is a reasonable price range for this setup...

Hi All, I'm lurking about for my first purchase, and have sort of settled on the fact that most all of the sub/compact units could do the job. I've found a couple of interesting units for sale, the above models. Both are cab power shuttle units with FELs, so all things being equal, which would...