Search results

What controls how far the main piston come up toward the seat on a BH75. when you pull up on the main boom the main arm come up too far. Is how far the piston goes in the clylinder controlled buy the cylinder or the control panel with the levers and relief valves. I saw some post on the main...

I've owned the tractor for 6 years but will be first time i need to haul myself. should i get 4 come a long chains , one for each wheel . Or two longer chains? What should the chain be rated at. any other suggestions? its a 4 wheel trailer.

I noticed today after cutting grass with rotary cutter and I was checking the blades that i could turn the PTO shaft when i pulled one of the blades towards me. Tractor was off naturally and PTO control lever was set off for PTO. Maybe I never noticed but I remember having to take the shaft off...

Should the spacers go on before or after you put the hitch arms on. I've looked in manual but have a hard time seeing which goes on 1st or does it matter? I use it with a 5 foot rotary cutter. thanks Bob

I've noticed since last fall i hear a whine or squeal from the transmition area when moving. If i stop the whinning stops. This is only for the 1st 5-10 minis then no noise. Is this something i should be concerned about or any ideas what its from or what i can check? It has 320 hours and use SUDT.

I have my tractor in Laurel Highland of SW PA , temps could go below zero a few times durning the winter. I have it stored in heated garage normally as i do not use it in the winter. I might have to move it ouside in an open equipment storage area. Should i at least cover it with tarp and is...

I was driving the tractor back and noticed the fuel cap was lower than the hood on the tractor and gauge was reading close to full, i new there must only be 1/2 full though. Tractor was running fine, so got some screw drivers to get the cap off. I guess the vent must be clogged or cap on too...

Anyone know what the black knobe that turns is on down behind the right leg on the big boss transmistion. There is a brake calabier mounted on the transmistion. And a black knobe that turns. or how you would adjust the knob? The ATV is slipping out of gear easier than used too in high gear also...

Looking for a utility vehical to haul dirt and gravel. From what I've seen the Ranger 6x6 has payload of 1750, i looked at the specs on the Bobcat toolcat, it looks like will haul a lot more but pretty pricey. My main use is haul dirt and gravel a couple of miles on trails in a state park...