Search results

I have posted before about adding rear remotes using the Summit monoblock, primarily for top & tilt. Finally got around to it and finished it yesterday. Everything works as it should, but one small issue. When I first tested it, other than a few connections I had to tighten a bit more, there...

I am about to add rear remotes to my LX2610 - I already have a 3rd function and backhoe. I have it basically figured out (thanks to Dan/Thisoldhokie !) and found some information. The way the LX2610 is configured, PB off the loader valve goes to the third function, which then feeds the backhoe...

I was doing some work today with the Grapple and all of a sudden my loader was crooked. When I checked it the left side cylinder for curl was loose on the loader. The other right works and the bucket will curl, but no mater what position it is in the left side cylinder is loose and I am...

Long post, but bear with me, I want to add rear remotes to my Kubota LX2610. Yes, I have done some research and think I have the right solution, but want to run it by folks before I do. Important to note that I already have both a backhoe and a 3rd function valve installed. The backhoe is e...

So I am new to Hydraulics but am in the process of adding rear remotes to my LX2610 that would come off the power beyond supply lines I use for my BH77 backhoe. I think I have it figured out, but came across something doing my research that I would like to understand - I don't think I need it...