Search results

After I figured out the last problem (it wasn't the starter), I just didn't have the battery cables seated well enough on the new battery. So the tractor will start but none of the gauges or dummy lights work, neither do the turn signals or the horn. After starting the tractor I return the...

While trying to diagnose what I thought was a problem with my starter switch, I came across this part behind the dash and I am wondering if anyone can tell me what it is.

I am following the instructions in the operation manual from Murray Publishing on page 41 and have a few questions. 1. the new O-ring mentioned in step 5 is for the filter bowl and goes under the large nut not inside the bowl for the filter, right? 2. Step 6 says to "loosen the bleeder screw...

When I parked my YM2310 in the fall of 2010 I didn't plan on it being this long before I started it up again. Never the less that is what happened. It has been parked in the garage the whole time. I was planning on topping off the water in the battery and putting it on the trickle charger...

I have a RSB1300 tiller that I am using and the engine will lug and then race as the soil changes, so I wonder if I know what I am doing. Anyway, I was tilling under some field grass and the engine lugged too much and died. Now it will not start. Any ideas what I have done or what I can do to...

I am embarrassed to admit that I have misplaced my owners manual, but I suspect that my hydraulic fluid level is low. The dipstick down by my feet near the gear shifter has 3 X's on the end. Is it safe to assume that full is at the top of the 3rd X?

When I tried to start my YM2310 on Saturday I noticed sparks from the engine compartment. So, I opened the hood and observed while I had my son try to start the tractor. I saw sparks coming from 1 of the two large lugs on the end of the starter solenoid. I tried to start it again and just get...

When I have my tiller or box scrapper attached and I get tipped to either side just a little bit the attachment starts to rub against the tire on that side and it is tearing up the rubber. This also tends to happen when I am turning around. How do I keep my attachments from beating up my tires?

I just bought a Yanmar RSB 1300 tiller to use with my YM2310 and I am wondering what some of the knobs and levers do. Are there any manuals out there?