Search results

Im not shure on the brand of the unit but the gearbox says "five star" and all serial numbers and markings are rusted away, the input shaft turns with a pipe wrench and is slowly getting easier (the gearbox was full of water) this might sound very wrong but what if i just refill it with oil...

For some reason when i preheat, it dosn't glow but the glow plugs get warm but in no way hot as they should be, first i thought the connections so i cleaned all of them and same problem, the little coil does not glow even if i preheat for 40 seconds, it still takes about 3 tries to start the...

i am taking my older model b7100 kubota to the dealer on monday to run some pressure tests on the h.s.t. to see if they can figure out why it has low power, hopefully it will just be these pressure relief valves that i found out about on here, if so i was wondering if anyone has had these fixed...

so its a maschio rototiller around 5.5 feet, i picked it up because it's in amazing condition for its age but there was one problem, the tines look like straight knife edges (no curve in them anymore) under closer inspection they look as if they were machined this way because they are all...

i was looking at some small post hole drillers for my b7100 kubota and started thinking if it was possible to put a small post pounder on it instead, i was wondering if anyone has attemted this or could put me in the right direction, thanks!!!!!

i have not used my 3 point in many years but i tried lowering it the other day and with a full load on it it took a good 5 minuits to go all the way down, it was always slow but not this slow, so i think there is some kind of speed valve? no? i cannot find it, and im not shure but has anyone...

well for the past 5 years i have been using my little hst kubota with one big problem. It has been losing driving or push power (it has a front end loader) especially when it gets hot, i have changed both the 2 metal tubeular screen filters and the paper hydraulic filter and same problem. i put...