Search results

I recently acquired a ford sickle cutter and have completely refurbished and repaired all the parts. When putting the sickle bar back into the mower it binds up at the end on the ledger plates. I dont remember if i was able to move the sickle with my hands in and out before i took it apart...

Anyone know where i can locate some replacement twine knives for my IH 37 square baler? Thanks all. I am located near college station Texas.

I live in southcentral texas and I am looking to see what a reasonable charge for hay baling should be for both round bales and small square bales. Any help or feedback would be appreciated. I am looking to have 50 acres baled and wanted to have an idea of the cost associated with it.

I am sure this has been asked many time before but i need help disassembling my brush hog to replace the deck. The gearbox was bolted to a platform above the deck and the lower gear was between the platform and deck. I unbolted the gearbox on top and the lower gear box beneath the platform...

i am restoring a disc harrow that has a square axle. the bearings was a round bore with a 6" pipe going through it. The square axle slid through the pipe. Is this the correct setup for a square axle? I need to replace the bearings so should i get a square bore bearing or continue with the...

I am rebuilding an disc harrow and wondered if anyone could answer this question. The disc has a square 1 1/8" axle but the sealed bearings are round bore with a 6" piece of pipe through it. The square axle slides through the pipe and never engages the bearings. Was this suppost to be this...

I recently acquired a used 3pt sprayer rig. The pto pump is not attached to the rig. When i attach the pump to the pto shaft, how do i keep it from spinning? Any help would be appreciated. I am a newbie to the whole 3pt spray, never used one or set one up. Thanks all...

I had a dealer quote me a cash price for a JD 5203 4wd with 522 FEL for $23,570. Is this a good price? Thanks for all the help guys.

Ok here is my issue. I have a set amount to spend on a tractor 20k. I have 50 acres, which will be pasture and 10 acres of cultivation for wildlife. My land has a gentle grade of about 15 degrees slope from front to back. I can purchase a new JD 5203 2wd and FEL for about 19500 Or a used NH...

I just moved out to a farm i purchased, which is 50 acres. I have 20 acres hay pasture, 10 acres culitivated crops and 20 acres woodlands. I plan on someday baling my own hay but currently the neighbor does it for halves. What size tractor would best fit my place and would run baling...