Search results

Has anyone built one of these machines? It looks like a fairly simple setup, small hopper with a plunger to pack the Sandy cement mix into a die of the curb shape.

I can't seem to find the recommended tire pressure anywhere. Ct 230 w/r4 tire. From the dealer there is 65 psi. I've lowered it down to 15 (rear) and the ride and ground contact is better.

Here's my version of the 3rd function or aux valve for my ct230 with the 7tl loader. My cost so far is around $250.00. I wanted to keep the system basic, easy to remove, and I wanted to avoid cutting the wiring harness. Since I'll be removing the loader often, its needed to be easy to...

Just started a project today if anyone wishes to follow along.... I've got pieces to a 5 ft. Befeco finish mower that's seen better days. The original deck is a side discharge. After reading some posts about side vs. rear discharge, I decided that the new deck will be a rear discharge...

I'm converting my hydraulic pump from another project to a pto pump for my log splitter, backhoe, etc.. I purchased a coupler from surplus center to adapt the 3/4 pump shaft to the pto splines, and made a temporary mount to hold the pump. The setup worked, but I noticed the pump was twisting...

I'm looking for the male part of the quick connect fitting. it has the following on it, FASTER nv14-38saem-08Bo. I can't seem to find a cross ref part. thanks edit: loader quick connects

I added this to my trusty 8n after reading deerfans post. Built it from an old bedframe and a $5.00 husky tool box. Fits my grease gun, pins, flashlight,etc. and cooler right next to it behind the flag. Bolts right to the fenders. I cut the lettering out with my vinyl cutter.