Search results

My B219 loader seals were leaking so I bought the seal kits. I had previously replaced the seals on one of the lift cylinders and all was good. This time I needed to replace;ace the seals on the two bucket cylinders. However, I just can't loosen the nut! I'm afraid I will break or twist the...

My B7100 hydraulic implement lift has stopped operating. The check rod on mine is broken. Can anyone show where this should connect to? Ive seen drawings where the control or check rod connects to a bracket on the lift arm and seems to also connect to the raise/lowers lever. I just can't see how...

Our precious B7100 has started making a really loud and nasty noise when disengaging gears. I lengthened and shortened the intermediate rod (as listed in the I&T shop manual) but the noise is still there and we really can't run the tractor. My guess is the release bearing is totally shot. Is...

I have an old B7100 and would like to get an old finish mower for it for some light weed mowing. Anyone have any suggestions? Thanks!!!

We have an old B7100 4WD with a B219 Loader and we want a mower for it, preferably one of the rear mowers. Can any advise what mower we should get or where to find a used one? Thanks!

Our B7100 has had both rear wheels fall off about 4 times over the past 2-3 years. The factory part that holds the wheel on the axle is a brass(?) pin with a small spring clip on the end. I reverted to this recently and it lasted about 2 months. Previously I have been going with long bolts and...

We need a finish mower for our old faithful B7100 for mowing weeds at the back of our horse field. No idea where to start or what to look for. Any help or advice greaty appreciated thanks!

I have a B7100 4WD with a B-219 loader. The lever on the control valve which operates the bucket angle is seized solid; the up-down lever works fine. I can't seem to find a part number for the valve. Can any 2-spool valve be used? Does anyone have experience of repairing the original valve or...