Search results

I'm replacing the dynamo (if I can ever get the lower center nut off, then back on), and the coolant comes out of the engine in the same housing. I'm using a new gasket and I really don't want to have to do it twice. Should I use gasket sealant (permatex High temp red) , or use no sealant-just...

My rear seal for the driveshaft for the front wheel drive is leaking. I guess a stick pushed it in because the bottom is in 3/8in too far. Has anyone replaced one of these? It looks like it is installed from the outside but I'm not sure how to disconnect the driveshaft. It has a joint about 4 in...

My 2011 3038 won't hold bucket in curl. If I don't bump it up every 100yds it dumps. I had a 790 that did the same thing and was one of the reasons (although the hydrostat and hp were the main ones) that I traded. Any idea what would cause this problem? Thanks.

I got a new tractor and had dealer move my 3rd function diverter (electric from surplus center). When I went to use it, it would open but not close. I switched hoses and it would then close but not open. So I guess 1 hose is not being pressurized. I checked connections( they had wired backwards)...

My 790 with 419 loader has a problem when trying to slowly curl. Instead of curling the bucket goes down(dumps slightly). If you curl more aggressivly (even slighly more) it works fine. Anyone know waht I could check? Thanks

I'm looking for a lightweight grapple (48 in would be ok). All the ones in a search of threads are no longer available and I'd rather not have just a bucket addon type. The 419 FEL doesn't have much lift capacity but I don't plan to be lifting heavy loads. Also on the 790, what is this type...