Search results

my ford starts good but when you drive 20 ft it stalls out checked voltage reg ok . Fuel bulb ok . I think its timming or carb . What else? Thinking of a new Zenith . What do you think?

Are loaded R4 tires just as good as ag tires? Looking at new tractor with r4 tires dealer says just as good if not better . Tractor is 4wheel drive.

Going to look at a mf283 with a quick attach loader for 8500 , says low hours good shape . Is this a fair price for that tractor in good shape?

I have a 1958 841 gas and cant see any marks to set the timing on the fly wheel where are they located ? I have a loader connected to the fly wheel might this be the problem?

Anyone have any experience with the 2605 2 wheel drive . Its on sale for 9,999 . its 38 hp 32 pto . I need one to replace my 841 ford 45 hp gas . Will this pull a 2 bottom and a 8' offset disc ? I like the price only need it for 6 ac . Anybody have any thoughts Will

I have this old plow and would like to know how to clean it up . Painting and something for the wood .

I can purchase a 4110 for 4,200.00 with a loader and backhoe. Is this a good tractor and I think the price is good . It only has 325 hours.

Whats your take on a 150 gas I know the 150D gets good press but I am going to look at a 150G that there asking 3500 for with no loader . The price sounds good hope it looks and runs good.

Found a dealer with a 400 with loader no hours last years model gave me a price of 19500 it seems like a good price 4 wd with loader tires also. Will this tractor handel a 2 bottom 14 and a 7'6" disc He says no problem what do you think . My soil is not to hard I had used a old ford 45 hp before.

Just got my tractor out of gear it was stuck . He told me I should drain the trans and fill with gas lit sit 15 min. then drain and pressure wash and refill. Is there a better method or product to use I am kind of leary of the gas thinking it might be bad for the seals. Its a ford 841

My ford 841 is stuck in gear it wont come out. It was somking some after this happened so I stoped and pulled the cover plate . One of the gears was a little chewed up , The middle one looked like the biggest too. I always had a problem with 2nd so I thought this might be it but I cant move...

Are the new tractors using Sae or Metric Bolts ect?

Whats the recomended hyd oil change hrs. or time on a ford 841 ? I usually do about 30 to 50 hrs, a year.

I have my tire off my rear rim and inside there is some surface rust . i going to sand it and paint . I was going to use rustolem or are there better products, also the outside too.

After using my plow I coat it with greese for storage ,but I still get rust areas. Is there a better product to use or way to do It?

I have the kit to switch from points to electronic ignition,I also have to change the coil .Has anyone had any experience doing this? Its a 6 volt positive ground system.Would like to know if its worthwild. Thanks

Want to convert to electronic ignition from points . Have just bought kit . Has anyone done this to a 6 volt positive ground system ? Would like some advice. Thanks

What is the purpose of the tail wheel on a plow?