Search results

LET THERE BE LIGHT - TractorByNet.com Here is a link in the customization forum where I added lights to the L4400. I didn't know if anyone else had used the nuts I use to mount lights?

Well I added some lights to my L4400. There is a nut that is welded to the ROPS and I thought that I could use it. It looks like it would be for a canopy. I had my sheetmetal shop bend up some 12 gauge 316 SS. Then I drilled some holes and wired it up. The wires were there from the factory under...

This is not another thread about R1 vs. R4. (Even though R1 has better traction with all other variables out of the question.) But I have a L4400 with loaded R1's. Currently the tires are not set to there widest position. So I want to put them to the next widest setting but the problem is that...

I have a L4400 with a rear remote. I was runing a post driver over the weekend and had the remote locked in the forward position to act like a power beyond since the driver has a valve on it. When the remote was running I could not lift my 3pt but the loader worked fine. Is this some safety...

I have been running some hydraulic implemnets with my tractor and noticed that I was getting low on fluid. So I filled up the fluid so that the site glass was full. I then proceded to extend my loader and three point all the way up and saw that the site glass was all the way down and showed...

Last night I was mowing and was thinking about one of those degree indicators to tell you how close you are to tipping over then I looked and it seemed that the key on my L4400 in the run position was about 15 degrees. And from most everyone at TBN I know that 12-15 degree's is the most you...

I think something is going on with my HST. I have an L4400 with just 20 hrs on it and after mowing about 5 ac this weekend with a 72" bushog the hst makes a rattling noise when it is not moving and the HST pedal is in the neutral position. The rattling sounds like it is coming from a small...

I am a new owner of a L4400 HST and I love the thing. I wanted to see if anyone knew which line coming from the pump to the loader was the power beyond line there is a block on the outside of the pump just under the HST petal and there are three lines coming out of it. I assume one is supply...

After looking on the forums and around I finally bit the bullet and got my L4400. I only have a few hours on it and will post pic later. But one of the many things I wanted to do with the tractor is be able to move our horse trailer out of the overhang because it is much easier to manuver the...