Search results

I am looking to upgrade, and two of the possibilities are Massey Fergusons. The 1M.25 and 1E.25. I want to get R14 tires for snow, but R14s are not available in these models. I asked the salesman to see if MF would be offering R14 in the near future. I think that MF offers R14 on some models...

I recently discovered the existence of the Bercomac SSQA snowblower . I am not sure about the durability of it. Let me know if you have seen these. I'd like to hear what others have experienced. At the moment, it appears to me as an expensive gamble. It may be one of those you either love it or...

I am considering the CX2510 with a front mount snowblower. The dealer spec'd the SB54 snowblower. I have not been able to find videos of the install process for this combination. The videos that I did find for Kioti front mount snowblowers showed a large sub frame that gets attached to the...

Wondering what the opinions of owners are about how tipsy the mt255s is. I am considering one, with a front mount snowblower which is only one inch wider than the tires. So adding wheel spacers would not be an option if I buy one and decide that I would like more stability. Also, I think the...

I've seen some videos where people say that they use their compact or scut tractor to push over trees. The base of trees can hop up as they fall, so I'm wondering about peoples experiences with doing this with a smaller tractor. For an 8 or 10 inch diameter tree, maybe 60 feet or more tall...

I am considering a JD 2032 and need a front mount snowblower. I did a quick measurement on the width of the rear tires (R4 I think) and thought that the width was in the 58" range. But I've seen some videos of 54" blowers on the 2032 and the rear tires seem to fit in the path that the blower...

I have a JD 2305 that has always been an issue for my wife to operate. She is 5'4" and the tractor does not have enough fore/aft range in the seat adjustment for her. I am, finally, looking into fixing this. I have done some searching, and see that some people replaced the seat with something...

I had previously posted this in another forum and it was suggested that I post this in Hydraulics. I have a JD 2305 with a 200CX front end loader. Recently, when I attempt to curl the bucket down to dump a load, the FEL curls upwards. I can get it to curl down if I do not push the joystick...

I have a JD 2305 with a 200CX front end loader. Recently, when I attempt to curl the bucket down to dump a load, the FEL curls upwards. I can get it to curl down if I do not push the joystick fully to the right. But it goes much slower and if I push it too far it curls upward and I have to start...

I'm going to be changing the fan belt on my 2305. There is not much room to work around that belt. The owner's manual just says to loosen the mounting bolt and adjustment bolt, move the alternator and take the belt off. Installation is a similar procedure. I have my doubts that it is going to be...

This has probably already been asked, but my searching turned up nothing. I'm looking to xref a JD LVA121812 hydraulic filter for my 2305 tractor to a WIX filter. Does such a cross reference exist?