occasionally my YM240 will pop out of high range. This is one part of the tractor I haven't worked on. I have the manuals for it, just wanted to ask how to attack this from folks with experience. jbrd
I have a steering wheel for a YM1700D, It came with my Ym240, but won't work on the shaft. If anyone has a steering wheel for my ym240, or something welding related to trade, respond.jbrd
Many Thanks to all of you guys that nursed me along with my Ym240 project. The Tractor has my Bearcat 554 chipper on it, and the two together take care of alot of work! If anyone tackles a similar project, and wants to know a novices experiences, I'll try to add my two cents. Thanks again, jbrd
I have a bearcat 554 chipper/shredder on my Ym240. When I move the tractor with the chipper attached I have been closing the stop valve to keep it off the ground when I move it. The book says "do not close stop valve when transporting implement". The slow return valve is in the slow position...
I bought a chinese radiator for my ym240. It does not have a threaded opening for the petcock. It does have a small nipple on the lower left side where I attached a small piece of fuel line with a bolt stuck in the end with a couple of small clamps. Has anybody found the fitting that is...
I pulled the head off my ym240 & had it magna fluxed - no cracks. The I.D. # is 2TR18. Engine # is 2TR20A. Anyone else experienced this? The holes at the flywheel end of the block don't have matching holes to the water jacket on the head. The old head gasket wasn't blown. Just rust on the...
First, Thanks for all the great information from you guys. What is the recommended way to do a compression test? Leave one injector in, or take both of them out. Thanks, jbrd
Any advice on replacing the washer under the injectors? I can see where the white fiber washer goes on top of the upper chamber, but to put the copper washer under the upper chamber I'll need to pull that piece up, how is that done? I'm going by the diagram on Hoyes site where it says " What's...
Got my ym240 running! Looking for attachments, Any recommendations for a loader, backhoe or box blade? "California" has some great pictures, the hoe looks perfect. Thanks, jbrd
Has anyone replaced the steel fuel lines with lines other than the solid steel fuel lines, or where is a good place to find these lines? I tried Hoye - no luck. Thanks, jbrd
anyone know the way to rout the wires to the dash, and the proper location for the voltage regulator for the ym240? I have a new fuse box, has anyone rigged up a waterproof backing for this new fuse box? Thanks, jbrd