Search results

Are there any delete kits available for a John Deere 2017 4066m? There are a couple of videos on youtube but they are real short and do not give much info on how it would be done. Just looking information, and ideas at this time. The tractor has 37hrs and says it has 75% soot build up already...

I have a DK45se Hst I would like to know what the operating hydraulic pressure is on this machine, also if I am reading my book right it says that the pump capacity is 63.9 gpm. Can that be correct? That seems to be a little much to me. Any help on this will be greatly appreciated.

I have a DK45SE with fel w/4n1 and a backhoe. When I engage the backhoe one of the connectors going to the 4n1 control valve will start to leak not at the threaded connector but where it is crimped to the pipe. The only time it will leak is when the backhoe is in operation. I can use the bucket...

Can anyone give me a ball park price on rebuilding the hydraulic cylinders for a 4 in 1 bucket? Also can it be an at home project? Got a used 4in1 bucket the price was good, but got it home and on my fel and both cylinders leak one real bad the other not so much. Mechanic friend says I need to...

While digging around a stump with my new Kioti DK45se HST and KB2485 backhoe there developed an extra noise in the hydraulic controls of the backhoe. I tried to upload the video here but never could get it to go so the video can be viewed on YOUTUBE at Farmboync titled 12 19 14 1213pm extra...

Just took delivery of my new DK45SEH with 401 fel and backhoe attachment. This is my first BH and I need to know what rpm to run engine for best performance and efficiency? I will appreciate your info on this, I know it may be a dumb question but it's mine.:confused2:

Anyone know how much antifreeze needs to go into the rear tires of the DK 45se hst, total volume on chart is 47 gal. I would like to get them protected down to about 0 deg. F. Any help will be greatly appreciated. PS: Would like to know the MSRP for the KB 2485 backhoe?

Today my DK55 just died while rotter cutting. It sounded as though it was starved for air so I removed the air filter which was not real dirty, but it cranked right up and ran fine. I cleaned what little dust and dirt there was on it. The tractor ran fine after that. My question is. Is there an...

DK55 4wd 202hrs front differential locked up. Anyone know of trouble with this model and this problem? Would like to hear from you !!!:mur: It happened while loading dirt.

Having trouble with the pivot pieces on my quick attach bucket, that's those half-moon looking things. They keep bending, I replaced them and got local welder to add side support but they bent again (dealer says voided warranty by adding supports. Local welder and adviser says they should be...

My DK55 has 99 hrs. Today while I was greasing it to load some dirt I noticed that the right hub would not take grease. Then I noticed there was a large gap between the hub cap and the arm that goes down to the right wheel. I took some pictures and call the dealer mech. and he said he would have...

I am looking for an adhesive backed rubber tape that is also heat shrinkable. I would lake it to be 2 or 3 inches wide. Is there anyone that knows about this and where to get or any other info for a product like this.

On the DK55 where is the clutch drain plug? Would it be covered if fel on tractor? Do I need to remove it to wash my tractor or if it is left out in the rain?

I recently purchased a new DK55. I would like to know if anyone has had problems with motor side panels becoming unatached while working especially while using a rotory cutter. After I cut for a couple of hours or so I usually come in and take a break and blow the collected stuff off the tractor...