Search results

Have been working on tractor and need some help .we ran out of diesel on this tractor and after refueling and bleeding out system the tractor blows black smoke we checked compression and it ranged from 380 to 420 thought that's ok Checked injector timing also because not only smoke but tractor...

I've been working on this tractor and have checked injector timing and looks good and checked compression 380 to 420 psi not sure what compression should be but tractor starts up and blows a lot of black smoke and starts idling faster and faster on its own. It will not shut down with lever you...

Finished up a job with loader getting ready to load on trailer and brakes locked up. Checked fuses and traction fuse blown . Changed fuse Started tractor up and hit brake switch and fuse Burned again. Opened cab and solenoid in center of tractor burned up. Trip to bobcat for new solenoid and...

We have a small tractor it ran out of fuel and we bleed out system and tractor has a miss on 1 cylinder. I figured it was an injector so we pulled all and had rebuilt. Also checked compression and it was 300 plus so we installed all injectors back in tractor after having them rebuilt and tractor...

We were driving this tractor down the road and all the sudden the shredder dropped and steering quit . Checked fluid and it's full but now hydraulics . Someone said it could be the pump . Anything else that could be checked first? $$$$

We have a 1050 John Deere diesel and it ran out of diesel . We added fuel and bleed out system And now we noticed that when you run it diesel is getting into the oil and quite . It was running good before it ran out of fuel . We just changed oil week before and have ran it only about 2 hours ...

This tractor ran out of diesel when we got it started back up it started getting diesel in crankcase and looks like its leaking pretty bad any clues ? Thanks for your help

Does anyone know what the torque specs Are on this engine , i need to figure out What to torque the flywheel bolts

I ordered new main bearings for engine and the 3rd from rear was a 1 piece bearing and the new set came with a 2 piece bearing how do you install this type of bearing

Got on my backhoe the other day and it started right up checked all fluid levels pulled lever down to back up and tractor didn't move pushed lever forward and it didn't move noticed a warning light on And can't find my book , does anybody have a book on this tractor to help me out I will keep...

I have engine out of tractor and going to have overhauled. They said the crankshaft would have to be turned and the mains will be 20 and the rods 10 is that good or could this cause a problem just wondering

I have a 310 backhoe we were using and it quit digging with the bucket figured the way it acted we pulled cylinder and rebuilt it the bucket will curl out but curls in real slow fluid and filters are good has anyone had this problem before? Please help!!!

I have a 310D backhoe that we were using and the bucket quit curling we changed seals in cylinder and changed out the circuit relief valve and full of fluid. But it still wool not curl, everything else works great anybody ever had this problem?

I have a 4640 john Deere tractor and after running for about an hour all the hydralics shut down, I changed out all filters and cleaned the screen in bottom of trans. The screen was almost stopped up but clean now, still does same thing when hot after it cools down it starts moving again could...

I just bought a 4020 John Deere tractor and when you hook up shredder and lift it up it leaks back down on it's own I can lift again but it slowly goes back down need help please thanks. Rwelder

Hello I just purchased a 4020 John Deere tractor to use just for shredding and it runs great but noticed when you install shredder on back of tractor and start working it the 3 point hookup starts going down on it's own I can pick it back up but it works it's way down by itself any ideas thanks...