Search results

how do I remove an overrunning coupler from a ford 8n?

1947 8N been doing good till last week. Died while idling. Ran the bat down trying to restart. Charged the bat & tried again. Started a few times but died in less than a minute. Tapped on the carb with a wrench, fired up & ran just fine halfway back to the house. Spent the next few hours getting...

Still won't rev without choke. Fuel flow out of the carb seems good. It's cold here today so I wasn't able to get the wire terminal to come down through the angled boot but I checked plug gap and held a couple of them against the block while cranking, spark seems decent. Spraying WD had no...

got a problem with my 8n. seems to be fuel problem. starts fine. idles fine. won't rev up unless i close the choke halfway or more. rebuilt carb this fall. been running fine since then. checked inlet screen, removed carb & checked float setting, i use quality gas with seafoam in it. any ideas?

getting ready to replace throttle quadrant. don't see anything in either book about that. must be self explanatory. also need to know if there's a problem w/ using multi viscosity engine oil. i'm thinking rotella 15/40.

rebuilt the carb yesterday. turns out thats where a lot of my throttle control issues were coming from. sounds pretty good now. took my wife for ride last evening. still need to replace the throttle quadrant. it's worn pretty slick.

any tricks to hood removal & installation? we took it off in one piece. wasn't easy. took the main hood off the side panels to put it back on. i'm not sure which was worse. almost no access to the front bolts. wasn't able to remove the grill because of corrosion around the captured nuts. in...

hi i'm learning about my 1947 ford 8n