Search results

I purchased one for $115.00 on Amazon (Mr. Liance) for cleaning the dirt off the tractor and RZR. It works well for this.

See if you can find a email address for the place in China, translation would be easier. Replacing the head gasket is a very easy process if you're even remotely mechanical. My Jinma had the wrong head when I bought it allowing compression and fluid to get in through the water jacket.

I haven't used my backhoe since last summer, connected it up and it's not moving. I've got flow into the auxiliary pump but when the RPMs are up it comes out fast but sputtering like air is getting in. I've checked the tank filter the gasket seems good, I see no cracks or obvious signs that the...

Awesome job, Thank you !

It seems to have the power to split, it's never stopped regardless what I throw at it even with a four way wedge, it's just really slow.

The PTO pump is located right above the PTO at the 3 point hitch so real easy to connect, there is room for a tank along side. I'll have to see what the flow rate is to determine if it will be the same issue. There are no wheels one this one so it can't be "stand alone" and I would still need a...

I sincerely appreciate all the replies and information. Would adding a tank and attaching to the pto pump be an option (similar to how my backhoe works)

I have a 3 point log splitter I want to use with my Jinma 284, since there are no auxiliary hydraulic ports I connect it to the lines for the fel. It works ok but the cycle time on the splitter is very slow, slower than my gas powered splitter is. I had a friend suggest that the fel lines may...

I have two hydraulic quick connects on the rear of my tractor see attached images. I want to run a 3 point log splitter but I can't find any operation instructions. I have read that the flow of hydraulic fluid is controlled by the knob in front of the seat. Can anyone tell me the proper way...

Started to pull the head yesterday, was surprised to find a "pudding like" goop covering everything.

Ok here is the story... Back in October my tractor was leaking coolant from the water pump, wasn't sure if I would find a bad bearing or seal so I ordered new ones from Tommy at Affordable (super guy to work with by the way). Parked the tractor and pulled it apart. Cut to a few weeks later I...

Does anyone know a shop or mechanic that will work on a Jinma tractor in Massachusetts? Thank you

My tractor has started to grind when I shift gears. Seems like the clutch is not working. Is better in low range. Only 100 hours but I just bought it so I have no idea on how it was used prior to getting it. Any thoughts guys?

I joined a week or so ago, have already had great replies to a couple questions. I will be an enormous pain in the *** and you all will be sick of me and my novice questions but let me say in advance Thank you for your help. :cool:

I would like to have the option to make small repairs when needed and would like to give welding a try. I have an option for a stick welder or a flux wire welder. What is the difference in each' application and is there one that would be better for a novice? Suggestions? :confused2:

Hi gang, so I am new to this and just picked up a 2007 JM 284 with a HW03 BH. The former owner was not clear on the correct way to set the 3pt-h when operating the bh and the 2 lower bars twisted. He did some straightening and reinforcing but they clearly need to be replaced. There is a short...