Search results

I’ve been having problems with algae/microbes in my tank. What kind of bio side do you use?

Having free material is a good problem to have.

Wonder if I heat it on the tractor then use the hydraulic and lower it onto cinder block to straighten it?

When I lower the grapple the bent piece penetrates the ground before the other blades. Also keeps the unit off level causinsng difficulty mounting.

Functional is all I need

I’m a welder

It doesn’t wobbly

Haven’t thought about that one…will do

Not very well

All good ideas. I’ve thought about cutting then welding but I was going to try and straighten and reuse the bent parts. don’t think loader is bent. How would I know except for a visual?

Problem is it grabs before the other side touches. Plus it lays unlevel making it difficult to hook up. Think I’ll try heat then weld a plate on the corner. Thanks

I bent the outer tine on my titan root grapple. Ideas on best way to fix?

Are your uppers leather? Just checked my closet. Seven pair all standing tall. Good luck

Thank for the good replies. Everything turned out fine no damage. Dodged a bullet

Ok we usually do not get these kind of temperature (10) in the Houston, TX area. My tractor has both rear tires filled with water, No antifreeze. What can I expect except the obvious? I have two 500 gallon tanks, one red diesel the other unleaded- same question? My stuff is about a 100...

My JD 3038E with 144 hrs has developed an annoying issue. It starts immediately runs for about five seconds then shuts down. After cranking for about thirty seconds it will start again then repeat the symptoms. After the third or fourth time it will run fine the rest of the day until I shut...