Search results

I have a 2004 CK30 from new that has always worked in the 6 -10 range . With the small factory lever it was had to raise and lower . so I built an extion that slipps over the short lever and now it's much easer to use !

Were they putting some of the tires on going the wrong way ?

1200 - 1500 rpm at start ! Yikes ! I would never let it rev that high at start !

So your fuel supply - do you buy 5 gal at a time or have a tank of it ? Try a different source of fuel ?

Any chance of some Pic's ? most of us have neaver seen one removed !

I've heard so many Key Switch stories that is where I would look first ! Spray some WD-40 in the key hole ?

So - the 3 point hitch not going up or Down ?

I'll go stand in the Bad Ignition switch line !

How old is the Battery ? Just because you have 12.4 v. doesn't mean it's good ! Try jumping it .

I put on a pressure gauge so I know what the pressure is .

Looks like you need to set the rear wheel up one notch so the mower sets flat - 1/2" off the ground at all 4 corners .

I have a CK 30 - Idle is around 1000 rpm.

I did not understand the logic of building a CK 27 ? They already had the CK 30 !

When an old farmer was asked why he had such a big potbelly ? The farmer said " you always keep a roof over your favorite tool !"😊

After changing the Trans./Hyd. oil on our CK-30 Hst I now have 7 gallons of nice looking oil . Anyone know if this woud work as Chainsaw bar-oil ? Or any other good use for it ?

After reading the post about the runaway DK45s, I wondered why he didn't just pull the Emergency Engine Stop Knob ? Come to find out that tractor doesn't have one . Our CK 30 has one so the last time I shut the tractor off I used it to make sure it works. My question is how many CK25 - CK30...

This weekend I wanted to take a look at that beautiful Kioti engine . So I pull the knob and the hood pops up about 2" and stops as if it has a safety latch on a car. That's funny I don't remember it haveing a secound latch . Sooo I shut it and try again ! Same thing , so I tug on the hood and...

Today's job was to remove an overgrown Burning bush next to the house . It was about 10' tall x 10' wide ,with a 1' base . So I hook up a 20' chain w/ slip hook at the bush , and the other end to the CK30 HST. I'm in 4-wheel low , take the slack out of the chain , increase RPM's , nice and easy...

After replaceing our old Ferguson T30 with a new Kioti CK30H , I thought I would try fitting the old tire chains . Our Kioti has the industrial tires . The chains fit like a glove! I had to remove two sections from both sides , but the fit is perfect! Looks like the bars on the industrial tread...

While trying to use the cruise control feature on our new CK30H it would not stay set during field work . I contacted Daedong technical support and was told " That the cruise control only works in smooth operating conditions !" So for that 2 min. drive down the road it should realy come in...